3.
Loosen belt finger and rotate until there
is 1/32 – 1/16 in. (0.8 – 1.6 mm) gap
between belt finger and drive belt.
WARNING: Auger MUST NOT rotate
when the auger clutch bail is
disengaged.
4.
5.
Tighten belt finger.
Recheck gap between belt finger and
drive belt. Adjust belt finger until there is
1/32 – 1/16 in. (0.8 – 1.6 mm) gap
between belt finger and drive belt.
1.
2.
Start unit.
Engage auger clutch bail for 5 seconds.
IMPORTANT: Auger MUST STOP within 5
seconds of disengaging auger clutch bail.
Disengage auger clutch bail.
6.
Go to Check Auger Stopping Time next.
3.
Check Auger Stopping Time
•
If auger stops within 5 seconds, the
adjustment is complete.
WARNING: Improper adjustment
could result in death or serious injury.
Auger brake MUST DISENGAGE
when clutch is engaged. Auger brake
MUST STOP AUGER WITHIN 5
SECONDS of releasing auger clutch
bail.
• If auger does not stop within 5 seconds,
repeat the entire procedure in Drive Belt
Adjustment on page 16.
IMPORTANT: Replace the drive belt if the
Drive Belt Adjustment procedure has been
completed twice and the drive belt is still not
adjusted properly.
4.
Replace cowl.
WARNING: ROTATING PARTS can
cut off body parts. Keep hands and
feet away. Loose clothing, long hair
or scarves can get caught in rotating
parts and cause death or serious
injury.
1
2
3
1.
2.
3.
4.
Idler
Idler Nut
Belt Finger
Drive Belt
1/32 – 1/16 in.
(0.8 – 1.6 mm)
3
4
4
Figure 12
OS4501
GB - 17
Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | Ariens 938017, Ariens 938018, Ariens SS522EC, Ariens SS722EC |
Download File |
|
Document Type | Owner's Manual, Parts Catalog |
Language | English |
Product Brand | Ariens, Snow Blower |
Document File Type | |
Publisher | ariens.com |
Wikipedia's Page | Ariens |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)