Gas and Oil
Lower Handle
Lamp Wire
After assembly, service engine with gasoline, and
check oil level as instructed in the engine manual.
Alternator Lead
NOTE: Refer to Auger Control Test on page 8 prior to
operating your snow thrower. Read and follow all
instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
Figure 3
SECTION 3: KNOW YOUR SNOW THROWER
Operating Controls
Chute Directional Control
The chute directional control is located on left hand side
of the snow thrower.To change the direction in which
snow is thrown, rotate chute directional control as
follows:
WARNING: Be familiar with all controls and
their proper operation. Know how to stop the
machine and disengage them quickly.
•
•
Clockwise to discharge to the left.
Counterclockwise to discharge to the right.
Shift Lever
The shift lever is located in the center of the handle
panel. The shift lever may be moved into one of eight
positions. Run engine with throttle in the fast position.
Use the shift lever to determine ground speed.
Chute Clean-out Tool
WARNING: Never use your hand to clear a
clogged discharge chute. Shut off engine and
remain behind handles until all moving parts
have stopped before unclogging.
Forward: There are six speeds. Position one (1) is the
slowest. Position six (6) is the fastest.
Reverse: There are two reverse (R) speeds R1 and R2.
The “R2” closest to the operator (all the way back) is the
faster of the two.
The chute clean-out tool (see Figure 4) isdesigned to
clear a clogged discharge chute. Refer to Operating Your
Snow Thrower on page 9 for detailed instructions on how
toproperly use the chute clean-out tool.
Auger Control
The auger control is located on the left handle. Squeeze
the control to engage the augers; release to stop the
augers. The traction control must also be released.
Ignition Key
The ignition key must be inserted in the switch in order
for the engine to start. Remove the ignition key when
the snow thrower is not in use.
Traction / Auger Control Lock
The traction control is located on the right handle.
Squeeze the control to engage the wheel drive.
Release to stop.
NOTE: Do NOT “turn” the ignition key in an attempt to
start the engine.
Throttle Control
The throttle control is located on the engine. It regulates
the speed of the engine. See Figure 4.
This same control also locks the auger control so you
can turn the chute directional control without
interrupting the snow throwing process. If the auger
control is engaged with the traction control engaged,
the operator can release the auger control (on the left
handle) and the augers will remain engaged. Release
the traction control to stop both the augers and wheel
drive (auger control must also be released).
6
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD 31AE640F352, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)