1.
2.
Plug the battery charger into the port on the underside
of the battery housing, Figure 5-8.
5
Insert the battery charger plug into a standard 120
volt household outlet. See Figure 5-8. Charge battery
for 8 to 10 hours before initial use. Do not charge
longer than 12 hours.The battery should only need
to be charged upon initial setup and after any other
extended periods of non-use.
Maintenance
IMPORTANT: Always plug charger lead into battery pack
lead first, and then insert battery charger plug into 120
volt standard household outlet. Follow this order of action
every time you charge the battery.
3.
After charging, disconnect charger plug from outlet
first, then disconnect charger lead from battery.
Figure 5-9
WARNING
WARNING: Do not remove the battery
pack from the handle panel for any
reason other than replacement.
Off-Season Storage
The following steps should be taken to prepare your
lawn mower for storage.
The battery contains
corrosive fluid and
toxic material; handle
with care and keep
away from children.
Do not puncture,
1.
Clean and lubricate mower thoroughly as described
in the lubrication instructions.
Replacing Fuse (If Equipped)
The electric starter circuit and battery are protected by a
40 ampere fuse. If the fuse burns out, the electric starter
will not operate. If the unit fails to start with the electric
starter, perform the following steps to check the fuse
inside the battery housing:
2. We do not recommend the use of a pressure washer
or garden hose to clean your unit.
3.
4.
5.
Refer to engine manual for correct engine
storage instructions.
disassemble, mutilate
or incinerate the
1.
2.
Open the battery cover as described in Replacing
Battery. See Figure 5-6.
Coat mower’s cutting blade with chassis grease to
prevent rusting.
battery. Explosive
gases could be
Remove fuse from socket and inspect as shown in
Figure 5-9. If it is burned out, replace with standard
automotive 40 ampere fuse.
Store mower in a dry, clean area. Do not store next
to corrosive materials, such as fertilizer.
When storing any type of power equipment in a poorly
ventilated or metal storage shed, care should be taken
to rust-proof the equipment. Using a light oil or silicone,
coat the equipment, especially cables, and all moving
parts of your lawn mower before storage.
vented during charg-
ing or discharging.
Use in a well venti-
lated area, away from
sources of ignition.
3.
Carefully place wiring back into housing, close battery
cover, and fold upper handle back into place.
NOTEburns out.: The engine can be started manually if the fuse
Battery (If Equipped)
General Recommendations
The battery must be stored with a full charge. Extended
storage of a discharged battery will reduce life and
capacity of the battery.
Do not remove the
battery pack from the
handle panel for any
reason other than
replacement.
1.
Always observe safety rules when performing
any maintenance.
2.
The warranty on this lawn mower does not cover
items that have been subjected to operator abuse
or negligence. To receive full value from warranty,
operator must maintain the lawn mower as
instructed here.
3.
4.
5.
Changing of engine-governed speed will void
engine warranty.
All adjustments should be checked at least once each
season.
Periodically check all fasteners and make sure these
NOTE: The engine
can be started
manually if the fuse
burns out.
are tight.
13
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals |
|---|---|
| Tags | MTD 460 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)