4
KnowYour Lawn Mower
Blade Control Handle
Drive Control Handle
Operating
Your Lawn
Mower
Recoil
Starter
Electric Start (optional)
WARNING
Read, understand,
and follow all instruc-
tions and warnings
on the machine and
in this manual before
operating.
Height Adjustment
Mulching Plug
Levers
Figure 4-1
Blade Control Handle
Cutting Height Adjustment Levers
The blade control handle is located on the upper
handle of the mower. See Figure 4-1. The blade
control handle must be depressed in order to operate
the unit. Release the blade control handle to stop the
engine and blade.
One adjustment lever is located on each wheel and is
used to adjust the cutting height. All four levers have to be
at the same relative position to ensure uniform cut.
This blade control
mechanism is a
safety device. Never
attempt to bypass its
operations.
Before Starting
1.
2.
Service the engine with gasoline and oil as instructed
in the separate engine manual.
Drive Control Handle
The drive control handle is located on the upper
handle. Squeeze the drive control handle against the
upper handle to engage drive system. Release the
control handle to disengage the drive system in order
to stop, slow down, or backup.
Attach spark plug wire to spark plug. If unit is
Use extreme care
when handling
equipped with a rubber boot over the end of the spark
plug wire, make certain the metal loop on the end of
the spark plug wire (inside the rubber boot) is fastened
securely over the metal tip on the spark plug.
gasoline. Gasoline is
extremely flammable
and the vapors are
explosive.Never fuel
the machine indoors
or while the engine
is hot or running.
Extinguish cigarettes,
cigars, pipes and
other sources of
ignition.
Mulching Plug (optional)
3.
Before each use, check for proper drive clutch opera-
tion by performing the following before starting the
engine:
a. With the drive control released, push mower
forward. It should move freely. Pull mower back-
ward. It should move with only a small amount of
resistance.
b. If it does not the clutch may not be releasing
completely. Do not start the engine until corrections
have been made. Check the control cable for
severe bend, kinks and binding. Also check for
grass build-up around the belt.
The mulching plug is used to close the side discharge
chute opening when mulching or bagging grass. Do
not remove the hinged mulching plug at any time, even
when you are not mulching.
Recoil Starter
The recoil starter is attached to the right upper handle.
Stand behind the unit and pull the recoil starter rope to
start the unit.
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals |
|---|---|
| Tags | MTD 460 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)