4
Operating
Your Log
Splitter
Before Each Use
1.
Remove the oil plug and check hydraulic fluid level on
level ground. Maintain fluid level to just below oil plug.
Refill if necessary. Approved fluids include Dexron®
III, or 10 weight AW hydraulic oil.
B
2.
3.
Check engine oil level. Refill if necessary.
Fill up gasoline if necessary.
4. Lubricate the beam area where cylinder will slide with
engine oil. Do not use grease to lubricate. Make sure
to lubricate both the top and bottom of the beam face.
B
C
5.
Attach spark plug wire to the spark plug.
Using the Log Splitter
A
1.
Place the log splitter on level, dry ground.
a. Pull locking pin from cylinder base. See Figure 4-4.
b. Use handle to slide cylinder back to lock in place.
c. Reinstall pin.
Figure 4-4
2. Block the front and back of both wheels.
3.
Place the log against the push bracket. Only split
wood in the direction of the grain.
4.
To stabilize the log, place your hand only on sides of
log. Never place hand on the end between the log
and the splitting wedge.
Reverse
Neutral
5.
Only one adult should stabilize the log and operate the
control handle, so the operator has full control over the
log and the splitting wedge.
IMPORTANTfluid may be forced: Alwaysoutoperatethroughonthelevelair ventground,hole.otherwise
Forward
Control Handle
1.
2.
3.
Move hydraulic valve control FORWARD to split wood.
See Figure 4-5.
Release the hydraulic valve control to NEUTRAL
position to stop the cylinder movement.
Movecylinderhydraulicto the lockedvalve controlposition.BACK to return the
Figure 4-5
WARNING: Never remove partially split
wood from the wedge with your hands.
Fingers may become trapped between
split wood.
10
Categories | Lawn Mower Manual, MTD Lawn Mower Manuals |
---|---|
Tags | MTD 5DM |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | MTD, Lawn Mower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)