MTD 600 Series C D Style Snow Blower Owners Manual

Safe Handling of Gasoline
5.
Never run an engine indoors or in a poorly  ventilated area.
Engine exhaust contains carbon monoxide,  an odorless
and deadly gas.
To avoid personal injury or property  damage use extreme care
in handling gasoline. Gasoline is extremely  flammable and the
vapors are explosive. Serious  personal injury can occur when
gasoline is spilled on yourself  or your clothes which can ignite.
Wash your skin and change clothes immediately.
6
7
8
9
1
.
.
.
.
Do not operate machine while under the  influence of
alcohol or drugs.
Muffler and engine  become hot and can cause a burn. Do
not touch. Keep children away.
a.      Use only an approved gasoline  container.
Exercise extreme caution  when operating on or crossing
gravel surfaces. Stay alert  for hidden hazards or traffic.
b.      Extinguish all cigarettes, cigars,  pipes and other
sources of ignition.
Exercise caution when changing direction  and while
operating on slopes.
c.      Never fuel machine  indoors.
d.      Never remove gas cap or add fuel while the engine is
hot or running.
0.      Plan your snow-throwing pattern to avoid discharge
towards windows, walls, cars etc. Thus,  avoiding possible
property damage  or personal injury caused by a ricochet.
e.      Allow engine to cool at least two  minutes before
refueling.
1
1
1
1.      Never direct discharge at children, bystanders  and pets or
allow anyone in front of the machine.
f.
Never over fill fuel tank. Fill tank  to no more than ½
inch below bottom of filler  neck to provide space for
fuel expansion.
2.      Do not overload machine capacity by attempting to clear
snow at too fast of a rate.
g.      Replace gasoline cap and tighten securely.
3.      Never operate this machine without good visibility  or light.
Always be sure of your footing and keep a firm  hold on the
handles. Walk, never run.
h.      If gasoline is spilled, wipe it off  the engine and
equipment. Move machine to another area.  Wait 5
minutes before starting  the engine.
1
1
4.      Disengage power to the auger/impeller when transporting
or not in use.
i.
Never store the machine or fuel container  inside
where there is an open flame,  spark or pilot light
(e.g. furnace, water heater, space heater, clothes
dryer etc.).
5.      Never operate machine at high transport speeds  on
slippery surfaces.  Look down and behind and use care
when backing up.
j.
Allow machine to cool at least 5 minutes before
storing.
1
1
6.      If the machine should start to vibrate abnormally, stop
the engine, disconnect the spark  plug wire and ground it
against the engine. Inspect  thoroughly for damage. Repair
any damage before starting  and operating.
k.      Never fill containers  inside a vehicle or on a truck
or trailer bed with a plastic liner. Always  place
containers on the ground away from your  vehicle
before filling.
7.      Disengage all control levers and stop engine before  you
leave the operating position (behind  the handles). Wait
until the auger/impeller comes to a complete stop before
unclogging the chute assembly, making any adjustments,
or inspections.
l.
If possible, remove gas-powered equipment  from
the truck or trailer and refuel it  on the ground. If this
is not possible, then refuel such equipment  on a
trailer with a portable  container, rather than from a
gasoline dispenser nozzle.
1
8.      Never put your hand in the discharge or collector
openings. Always use the clean-out  tool provided to
unclog the discharge opening. Do  not unclog chute
assembly while engine is running.  Shut off engine and
remain behind handles until all moving  parts have stopped
before unclogging.
m.    Keep the  nozzle in contact with the rim of the fuel
tank or container opening at all times  until fueling is
complete. Do not use a nozzle lock-open  device.
Operation
1
2
9.      Use only attachments and accessories approved by the
manufacturer (e.g. wheel weights,  tire chains, cabs etc.).
1
2
3
4
.
.
.
.
Do not put hands or feet near rotating parts,  in the auger/
impeller housing or chute assembly. Contact  with the
rotating parts can amputate  hands and feet.
0.      When starting engine, pull cord slowly until resistance
is felt, then pull rapidly. Rapid retraction  of starter cord
(kickback) will pull hand and arm  toward engine faster than
you can let go. Broken bones, fractures,  bruises or sprains
could result.
The auger/impeller control lever is a safety  device. Never
bypass its operation. Doing  so makes the machine unsafe
and may cause personal injury.
The control levers must operate easily  in both directions
and automatically return to the disengaged  position when
released.
2
1.      If situations occur which are not covered in this manual, use
care and good judgment. Contact  Customer Support for
assistance and the name of your nearest servicing  dealer.
Never operate with a missing or damaged chute assembly.
Keep all safety devices in place and  working.
4
sectiOn 2 — iMpOrtant safe OperatiOn practices
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website