MTD 600 Series E F Style Snow Blower Owners Manual

Auger Shaft
Adjustments
At least once a season, remove the shear pins from  the auger
shaft. Spray lubricant inside  the shaft and around the spacers
and the flange bearings found  at either end of the shaft.
See Fig. 6-3.
Shift Cable
If the full range of speeds (forward  and reverse) cannot be
achieved, refer to the figures to the right  and adjust the shift
cable as follows:
1
2
.
.
Place the shift lever in the fastest forward  speed position.
Loosen the hex  nut on the shift  cable index bracket. See
Fig. 6-4.
Figure 6-3
Figure 6-4
3
4
.
.
Pivot the bracket downward to take up slack in the cable.
Retighten the hex nut.
Auger Control
Refer to the Assembly and Set-up section  for instructions on
adjusting the auger control cable.
Chute Assembly
Refer to the Assembly and Set-up section  for instructions on
adjusting the skid shoes chute assembly.
Skid Shoes
Refer to the Assembly and Set-up section  for instructions on
adjusting the skid shoes.
16
sectiOn 6— Maintenance & adjustMents
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website