MTD 600 Series E F Style Snow Blower Owners Manual

7
Service
Belt Replacement
3.
4.
Carefully pivot the snow thrower up and forward  so that it
rests on the auger housing.
Auger Belt
Remove the frame cover from the underside  of the snow
thrower by removing four self-tapping  screws which secure
it. See Fig 7-3.
To remove and replace your snow thrower’s auger belt,  proceed
as follows:
1
.
To prevent spillage, place a piece of plastic wrap  under the
gas cap and tighten securely.
2
.
Remove the plastic belt cover on the front of  the engine by
removing the two self-tapping  screws. See Fig. 7-1.
Figure -3
5
.
Remove the belt as follows. See Fig. 7-4.
a.      Loosen and remove the shoulder  screw which acts
as a belt keeper.
Figure -1
b.      Unhook the support bracket spring from  the frame.
2
.
Roll the auger belt off the  engine pulley. See Fig. 7-2.
Figure -4
Figure -
18
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website