•
Thread the ferrule onto the shift rod, up or down the
shift rod and align with the far hole on the narrow
side of the shift lever assembly behind the handle
panel. See Figure 10.
•
•
Make certain all cables are in the grooves of the
cable roller guides in the lower rear of the unit, one
on each side. Refer to Figure 9.
Thread the coupling end of the cable onto the
threaded portion of the Z fitting until the rubber
bumper (located on the underside of the clutch
lever) only lightly contacts the upper handle.
Shift Lever
Traction
Drive
Clutch
Auger
Drive
Flat
Washer
Ferrule
Clutch
IMPORTANT: The cable should have very little slack, but
should NOT be tight. An overtightened cable may
prohibit the auger and drive from disengaging.
WARNING: Over-tightening the cable
may prohibit the auger and drive from
disengaging and compromise the safety
of the snow thrower. Do NOT overtighten
the cable.
Hairpin
Clip
Shift Rod
•
Once properly adjusted, tighten the jam nut against
the coupling end of the cable to lock it in position.
Flat
Washer
Hairpin
Clip
Shift Arm
Assembly
NOTE: Refer to Auger Control Test in the Operation
Section prior to operating your snow thrower. Read and
follow all instructions carefully and perform all
adjustments to verify your snow thrower is operating
safely and properly.
Figure 10
Attaching the Chute Assembly
(Hardware F)
•
Secure the ferrule to the shift arm assembly with
the flat washer and hairpin clip.
•
•
•
Place chute assembly over chute opening, with the
opening in the chute assembly facing the front of
the unit.
Place chute flange keepers beneath lip of chute
assembly, with the flat side of chute flange keeper
facing downward. See Figure 12.
Insert hex bolt up through chute flange keeper and
chute assembly and secure with hex lock nut. After
assembling all three chute flange keepers, tighten
all nuts and bolts securely. Do not overtighten.
Attaching Clutch Cables
(Boxed & Crated Unit) (Hardware D)
Z fittings with jam nuts might be already inserted in
each control lever (on the handle panel) at the factory.
To attach the cables to the Z fittings, proceed as
follows:
NOTE: Two extra jam nuts are included in the
hardware pack in the event either are lost during
shipping.
Chute Assembly
Hex Bolt
•
If Z fittings are not already attached, thread hex
nuts onto the “Z” fittings and insert “Z” fitting into
hole in clutch grips. See Figure 11.
Hex Lock Nut
Z Fitting
Hex Nut
Chute Flange
Keeper
Cable Should
Be Straight
Figure 12
NOTE: Lock nuts cannot be threaded onto a bolt by
Figure 11
hand. Tighten with two 7/16” or adjustable wrenches.
•
If Z fittings are already attached, thread the jam
nuts all the way up each of the Z fittings, toward the
handle panel.
9
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD 614E, MTD 644E, MTD 664G, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Lawn and Garden readers have rated MTD 614E 644E 664G Snow Blower Owners Manual 3.0 out of 3.0 based on 1 product reviews. Where is the carburator on the unit. Can I prime it to get it started?