3
Tire Pressure
The proper inflation pressure is 20 psi. Check the tire
pressure periodically and maintain equal pressure in both
tires at all times. Excessive pressure (well above 20 psi)
may cause the wheel (tire/rim) assembly to burst with
sufficient force to cause serious injury. Do not over-inflate
High Position
Setting Up
Your Snow
Thrower
Middle Position the tire. Use a manual pump or portable electric tire
Low Position
inflator to prevent over-inflation. NEVER USE AN AIR
COMPRESSOR.
Skid Shoe
The space between the shave plate and the ground
can be adjusted. See Figure 7. For close snow removal,
place skid shoes in the low position. When the area to
be cleared is uneven, place skid shoes in the middle or
high position. See Figure 4.
WARNING
Figure 4
1. Adjust skid shoes by loosening two hex nuts and
carriage bolts on each skid shoe, and moving the
skid shoe to the desired position. See Figure 4.
Do not over-tighten
the cable. Over-
tightening may
2.
Make certain the entire bottom surface of skid shoe
is against the ground to avoid uneven wear on the
skid shoes.
Tighten nuts and bolts securely.
Drive Cable
3.
prevent the auger
from disengaging
and compromise the
safety of the snow
thrower.
Routing The Drive Cable
1.
Make sure that the drive cable is routed parallel to
the left upper handle, then across the top of the
lower handle and finally parallel to the right lower
handle. See Figure 5.
Three cable ties have been used to loosely tie the
two control cables to the lower handle. Two of these
cable ties are on each arm, and third on the top
cross bar of the lower handle. Tighten these cable
ties to secure the cable to the lower handle. See
Figure 5.
Cable Ties
Auger Cable
2.
If auger continues
to rotate with the
control disengaged,
shut off engine and
readjust.
Figure 5
Auger Cable
Periodic adjustment to the auger control cable may be
required due to normal stretch and wear on the belt.
Adjustment is needed if the augers seem to hesitate
while turning, but the engine maintains speed, or
continue turning with the auger control disengaged.
Never attempt to
clean chute or make
any adjustment while
engine is running.
1.
Loosen the rear hex bolt on the cable adjustment
bracket. See Figure 6.
2.
Slide the cable adjustment bracket backwards
taking out the slack in the auger cable.
Retighten the rear hex bolt
Over-inflating the
tire with excessive
pressure (well above
20 psi) may cause
the tire/rim to burst
with sufficient force
to cause serious
pressure.
3.
4.
Start engine and verify auger control engages and
disengages properly.
Figure 6
7
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD 769-04165, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)