MTD Cub Cadet 521E Snow Blower Owners Manual

SECTION 2:  ASSEMBLING YOUR SNOW THROWER
Unpacking From Carton
Before Assembly
Cut along corners of the carton and lay it down flat.
See Figure 1. Remove packing material.
Remove any loose parts included with unit (i.e.,
operators manual, etc.).
Roll unit out of carton. Check carton thoroughly for
any remaining loose part.
WARNING: Disconnect the spark plug wire
and  ground  it  against  the  engine  to  prevent
unintended starting.
Raising Upper Handle
Loosen the hand knob on each side of the handle.
Remove packing material, if any.
Remove loose parts
Raise
handle
to here
Hand Knob
Roll unit out
Figure 1
Hardware Pack
1.
Ignition Keys* (2)
Figure 3
*One key may be in the switch on snow thrower.
(Items 2 to 5 are illustrated in Figure 2.)
Raise the upper handle in the direction shown in
Figure 3 till it clicks into the operating position.
Make sure not to pinch or crimp the cable.
Tighten the hand knobs.
2.
3.
4.
5.
Eyebolt
Saddle Washer 5/16" I.D.
Hex Nuts 5/16-18 Thread (2)
Cotter Pin
Attaching Control Cable
The control cable may already be attached to the
control handle. If not attached, complete the following
steps to attach it to the snow thrower housing.
Eye Bolt
Route the control cable over the lower handle.
Insert the end of the cable into the hole in the
control housing as shown in Figure 4. Push the
plastic fitting until it locks into the control housing.
Hex Nut
Saddle
Washer
Cotter Pin
Figure 2: Hardware Pack
“Z” End
Bottom
of Cable
Hole In
Items Required For Assembly
Pair of pliers (not necessary, but helpful)
Two cycle engine oil (included)
Fresh gasoline
Control
Handle
1.
2.
3.
Control
Housing
Plastic
Fitting
NOTE: All references to left or right side of the snow
thrower is from the operating position only.
Figure 4
5
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website