MTD Cub Cadet 724 STE 926 STE Snow Blower Owners Manual

Reassemble the new friction wheel rubber to the
friction wheel plates and hub, tightening the six
screws in rotation and with equal force.
Position the friction wheel assembly up onto the pin
of the shift rod assembly, and slide the shaft
through the assembly. Reassemble in reverse
order.
Friction Wheel
Drive Plate
Drive Belt
Stop Bolt
NOTE: If you placed plastic film under the gas cap, be
certain to remove it.
Hex Bolt
Washer
Support Bracket
Track
Figure 18
Servicing Friction Wheel Rubber
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
Drain the gasoline from the snow thrower, or place
a piece of plastic under the gas cap.
Tip the snow thrower up and forward, so that it rests
on the housing.
Remove the six self-tapping screws from the frame
cover underneath the snow thrower.
Using a 7/8" wrench to hold the shaft, loosen, but
do not completely remove, the hex bolt and washer
on the left end of the shaft. See Figure 19 and
Figure 20.
Figure 20
Shift Rod
Assembly
Lightly tap the hex bolt to dislodge the ball bearing
from the right side of frame before removing the hex
bolt and washer from the left end of the shaft.
Move the shaft to the right and slide the friction
wheel assembly from the shaft.
Remove the six screws from the friction wheel
assembly (three from each side). Remove the
friction wheel rubber from between the friction
wheel plates. See Figure 18
Sprocket
Spacer
Pin
Friction Wheel
Assembly
Support
Bracket
Screws
Shaft
Friction Wheel Rubber
Figure 21
Hub
Off Season Storage
Screws
WARNING:  Never  store  engine  with  fuel   in  tank
indoors or in enclosed, poorly ventilated areas where
fuel fumes may reach an open flame, spark or pilot light
as on a furnace, water heater, clothes dryer, or other
gas appliance.
Friction Wheel Plates
Figure 19
Clean snow thrower thoroughly.
Lubricate as instructed above with light oil.
15
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 30 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website