Figure 19
•
•
•
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 20.
Slip belt between friction wheel and friction wheel
disc. See Figure 20. Remove and replace belt.
Reassemble following the instructions in reverse
order.
•
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 20.
Friction Wheel
Friction
Wheel Disc
NOTE: The support bracket must rest on the stop bolt
after the new belt has been assembled. See Figure 20.
Drive Belt
Stop Bolt
Servicing Friction Wheel Rubber
WARNING: Disconnect the spark plug wire
and ground it against the engine to prevent
unintended starting. Drain fuel into an
approved container or place a piece of plastic
film underneath the gas cap to prevent
gasoline from leaking.
Auger Pulley
Support Bracket
Figure 20
The rubber on the friction wheel is subject to wear and
should be checked after 25 hours of operation, and
periodically thereafter. Replace the friction wheel
rubber if any signs of wear or cracking are found.
NOTE: Loosening the six nuts that connect the frame to
the auger housing may aid in belt removal.
•
Lift the auger belt from the auger pulley, and slip
belt between the support bracket and the auger
pulley. See Figure 17. Repeat this step for the front
auger belt.
•
Drain the gasoline from the snow thrower.
•
Replace the auger drive belt by following
instructions in reverse order.
Drive Belt
•
Follow the first four steps of the instructions for
servicing the auger belt.
•
Pull idler pulley up, and lift belt off engine pulley and
friction wheel disc. See Figure 18.
15
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 724 WE, MTD 724 WE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)