3
7.
Attaching Grass Catcher to Mower
a. Lift the rear discharge door.
b. Place the grass catcher on the pivot rod. Let go
of discharge door so that it rests on the grass
catcher. See Figure 3-5.
B
A
WARNING: Never operate mower
unless the hooks on the grass
catcher are firmly seated on the pivot
rod, and the rear discharge door
rests firmly against top of the grass
catcher.
Setup and
Adjustments
8.
9.
To install the rear mulching plug.
a. Liftandrearout,dischargeoff of the pivotdoorrod.and lift grass catcher up
b. Insert3-4 andthereleaserear mulchingthe rearplugdischargeas showndoor. in Figure
NOTE: Make certain
bag is turned right side
out before assembling
(warning label will be on
the outside).
Figure 3-5
If converting to side discharge, make sure grass
catcher is off unit and rear mulching plug is in place.
A
a. Onmulchingthe sideplug.of theSeemowerFiguredeck,3-6. lift the hinged
NOTE: Make certain
cables are routed to the
outside of the handle so
they are not in the way
when attaching the grass
catcher.
b. Slide the two hooks on the side discharge deflec-
tor under the hinge pin on the hinged mulching
plug assembly. Lower the hinged mulching plug.
NtimOeT,Ee:vDenownohterneymoouvaertehenohtinmguelcdhminugl.ching plug at any
B
Adjustments
Drive Control
The adjustment wheel is located in the drive control
handle housing and is used to tighten or loosen the
drive belt. You will need to adjust the drive control if
the mower does not propel itself with the drive control
engaged or if the mower’s wheels hesitate with the drive
control engaged. If either of these conditions occur, rotate
the adjustment wheel clockwise to tighten the cable or
counterclockwise to loosen the cable, Figure 3-7.
Figure 3-
WARNING
Never operate mower
unless the hooks on
the grass catcher are
firmly seated on the
pivot rod, and the
rear discharge door
rests firmly against
top of the grass
B
catcher.
All mowers are
C
A
equipped with a rear
protective guard. The
guard helps eliminate
projectiles thrown
by the blade from
injuring the operator.
DO NOT REMOVE
THIS GUARD.
Figure 3-
Cutting Height
The height adjuster determines the cutting height of
the mower. The adjuster is located above the left rear
wheel. To adjust the cutting height, pull the lever out and
away from the mower and then move it forward or back
to select a new cutting height. See Figure 3-8.
Figure 3-8
| Categories | Gold Lawn Mower Manuals, Lawn Mower Manual, MTD Lawn Mower Manuals |
|---|---|
| Tags | Gold 839, MTD 839 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)