Operation
18. Never put your hand in the discharge or collector
openings. Always use the clean-out tool provided to
unclog the discharge opening. Do not unclog chute
assembly while engine is running. Shut off engine
and remain behind handles until all moving parts
have stopped before unclogging.
1.
Do not put hands or feet near rotating parts, in the
auger/impeller housing or chute assembly. Contact
with the rotating parts can amputate hands and
feet.
2.
3.
4.
5.
The auger/impeller control is a safety device. Never
bypass its operation. Doing so makes the machine
unsafe and may cause personal injury.
The controls must operate easily in both directions
and automatically return to the disengaged position
when released.
Never operate with a missing or damaged chute
assembly. Keep all safety devices in place and
working.
Never run an engine indoors or in a poorly
ventilated area. Engine exhaust contains carbon
monoxide, an odorless and deadly gas.
Do not operate machine while under the influence
of alcohol or drugs.
19.
Use only attachments and accessories approved
by the manufacturer (e.g. wheel weights, tire
chains, cabs etc.).
20.
If situations occur which are not covered in this
manual, use care and good judgment. Contact your
dealer or call 1-800-800-7310 for assistance and
the name of your nearest servicing dealer.
Maintenance & Storage
1.
Never tamper with safety devices. Check their
proper operation regularly. Refer to the
maintenance and adjustment sections of this
manual.
6.
7.
8.
2.
Before cleaning, repairing, or inspecting machine
disengage all controls and stop the engine. Wait
until the auger/impeller come to a complete stop.
Disconnect the spark plug wire and ground against
the engine to prevent unintended starting.
Check bolts and screws for proper tightness at
frequent intervals to keep the machine in safe
working condition. Also, visually inspect machine
for any damage.
Muffler and engine become hot and can cause a
burn. Do not touch.
Exercise extreme caution when operating on or
crossing gravel surfaces. Stay alert for hidden
hazards or traffic.
3.
9.
Exercise caution when changing direction and
while operating on slopes.
10.
Plan your snow-throwing pattern to avoid discharge
towards windows, walls, cars etc. Thus, avoiding
possible property damage or personal injury
caused by a ricochet.
4.
5.
Do not change the engine governor setting or over-
speed the engine. The governor controls the
maximum safe operating speed of the engine.
Snow thrower shave plates and skid shoes are
subject to wear and damage. For your safety
protection, frequently check all components and
replace with original equipment manufacturer’s
(OEM) parts only. “Use of parts which do not meet
the original equipment specifications may lead to
improper performance and compromise safety!”
Check controls periodically to verify they engage
and disengage properly and adjust, if necessary.
Refer to the adjustment section in this operator’s
manual for instructions.
11.
12.
13.
Never direct discharge at children, bystanders and
pets or allow anyone in front of the machine.
Do not overload machine capacity by attempting to
clear snow at too fast of a rate.
Never operate this machine without good visibility
or light. Always be sure of your footing and keep a
firm hold on the handles. Walk, never run.
Disengage power to the auger/impeller when
transporting or not in use.
14.
15.
6.
Never operate machine at high transport speeds on
slippery surfaces. Look down and behind and use
care when backing up.
7.
8.
9.
Maintain or replace safety and instruction labels, as
necessary.
16.
17.
If the machine should start to vibrate abnormally,
stop the engine, disconnect the spark plug wire and
ground it against the engine. Inspect thoroughly for
damage. Repair any damage before starting and
operating.
Disengage all controls and stop engine before you
leave the operating position (behind the handles).
Wait until the auger/impeller comes to a complete
stop before unclogging the chute assembly, making
any adjustments, or inspections.
Observe proper disposal laws and regulations for
gas, oil, etc. to protect the environment.
Prior to storing, run machine a few minutes to clear
snow from machine and prevent freeze up of auger/
impeller.
10.
11.
Never store the machine or fuel container inside
where there is an open flame, spark or pilot light
such as a water heater, furnace, clothes dryer etc.
Always refer to the operator’s manual for proper
instructions on off-season storage.
4
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)