RULES FOR SAFE OPERATION
•
Use the right tool. Only use this tool for its intended purpose.
SAFETY WARNINGS FOR GAS UNITS
•
•
•
Store fuel only in containers specifically designed and
approved for the storage of such materials.
• Do not overreach. Always keep proper footing and balance.
•
Always hold the unit with both hands when operating. Keep a
firm grip on both handles or grips.
Avoid creating a source of ignition for spilled fuel. Do not
start the engine until fuel vapors dissipate.
•
Keep hands, face, and feet at a distance from all moving
parts. Do not touch or try to stop the cutting attachment
when it rotates.
Always stop the engine and allow it to cool before filling the
fuel tank. Never remove the cap of the fuel tank, or add fuel,
when the engine is hot. Never operate the unit without the
fuel cap securely in place. Loosen the fuel tank cap slowly to
relieve any pressure in the tank.
•
•
Do not touch the engine, gear housing or muffler. These parts
get extremely hot from operation, even after the unit is turned off.
Do not operate the engine faster than the speed needed to
cut, trim or edge. Do not run the engine at high speed when
not cutting.
•
•
Add fuel in a clean, well-ventilated outdoor area where there
are no sparks or flames. Slowly remove the fuel cap only
after stopping engine. Do not smoke while fueling or mixing
fuel. Wipe up any spilled fuel from the unit immediately.
Always wipe unit dry before using.
•
•
Always stop the engine when cutting is delayed or when
walking from one cutting location to another.
Move the unit at least 30 feet (9.1 m) from the fueling source
and site before starting the engine. Do not smoke or allow
sparks and open flames near the area while adding fuel or
operating the unit.
If you strike or become entangled with a foreign object, stop
the engine immediately and check for damage. Do not
operate before repairing damage. Do not operate the unit
with loose or damaged parts.
WHILE OPERATING
•
•
Stop the unit, switch the engine to off, and disconnect the
spark plug for maintenance or repair.
•
Never start or run the unit inside a closed room or building.
Breathing exhaust fumes can be fatal. Operate this unit only
in a well-ventilated outdoor area.
Use only original equipment manufacturer replacement parts
and accessories for this unit. These are available from your
authorized service dealer. Use of any unauthorized parts or
accessories could lead to serious injury to the user, or
damage to the unit, and void your warranty.
WARNING: Gasoline is highly flammable, and its
vapors can explode if ignited. Take the following
precautions:
•
•
Keep unit clean of vegetation and other materials. They may
become lodged between the cutting attachment and shield.
•
Wear safety glasses or goggles that meet ANSI Z87.1
standards and are marked as such. Wear ear/hearing
protection when operating this unit. Wear a face or dust
mask if the operation is dusty.
To reduce fire hazard, keep the engine and muffler free from
grass, leaves, and excessive grease.
AFTER USE
•
•
•
Wear heavy long pants, boots, gloves and a long sleeve shirt.
Do not wear loose clothing, jewelry, short pants, sandals or
go barefoot. Secure hair above shoulder level.
Clean cutting blades with a household cleaner to remove any
gum buildup. Oil the blade with machine oil to prevent rust.
•
Lock up and store the cutting blade in an appropriate area to
protect the blade from unauthorized use or damage.
The cutting attachment shield must always be in place while
operating the unit as a trimmer. Do not operate unit without
both trimming lines extended, and the proper line installed.
Do not extend the trimming line beyond the length of the
shield.
OTHER SAFETY WARNINGS
•
•
•
•
Never store a fueled unit inside a building where fumes may
reach an open flame or spark.
•
This unit has a clutch. The cutting attachment remains
stationary when the engine is idling. If it does not, have the
unit adjusted by an authorized service technician.
Allow the engine to cool before storing or transporting. Be
sure to secure the unit while transporting.
Store the unit in a dry area, locked up or up high to prevent
unauthorized use or damage, out of the reach of children.
•
•
Adjust the D-handle to your size in order to provide the best
grip.
Never douse or squirt the unit with water or any other liquid.
Keep handles dry, clean and free from debris. Clean after
each use, see Cleaning and Storage instructions.
Be sure the cutting attachment is not in contact with anything
before starting the unit.
•
•
Use the unit only in daylight or good artificial light.
•
Keep these instructions. Refer to them often and use them to
instruct other users. If you loan someone this unit, also loan
them these instructions.
Avoid accidental starting. Be in the starting position
whenever pulling the starter rope. The operator and unit must
be in a stable position while starting. Refer to
Starting/Stopping Instructions.
SAVE THESE INSTRUCTIONS
2
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, MTD Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | MTD H70SS |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)