MTD S 230 240 250 260 261 Single Stage Snow Blower Owners Manual

8
Problem
Cause
Remedy
1.
2.
3.
4.
Choke not in ON position.
Spark plug wire disconnected.
Fuel tank empty or stale fuel.
Engine not primed.
1.  Move choke to ON position.
2.  Connect wire to spark plug.
3.  Fill tank with clean, fresh gasoline.
4.  Prime engine as instructed in
Engine fails to start
OperatingYour SnowThrower”.
Trouble-
Shooting
5.
6.
7.
8.
Clean, adjust gap, or replace.
Clean fuel line.
5.
6.
7.
8.
Faulty spark plug.
Blocked fuel line.
Insert key fully into the switch.
Open fuel shut-off valve.
Safety key not in ignition on engine.
Fuel shut-off valve closed. (If
Engine runs erratic
1.  Unit runningonCHOKE.
.  Blockedfuel lineor stalefuel.
.  Water or dirt infuel system.
.  Carburetor out of adjustment.
1.  Move choke lever to OFF position.
2
2.  Clean fuel line; fill tank with clean,  
fresh gasoline.
NOTE: This section
addresses minor
service issues. For
further details, contact
customer assistance.
3
3.  Drain fuel tank. Refill with  
fresh fuel.
4
4.  Contact Service Center.
Engine overheats
1. Carburetor not adjustedproperly.
1.  Loose parts or damaged auger.
1.  Contact Service Center.
Excessive
Vibration
1.  Stop engine immediately and
disconnect spark plug wire. Tighten
all bolts and nuts. If vibration
continues, have unit serviced by a
Service Center.
Loss of power
1.  Sparkplugwireloose.
1.  Connect and tighten spark plug
wire.
2.  Gascapvent holeplugged.
2.  Remove ice and snow from gas
cap. Be certain vent hole is clear.
3.  Exhaust port plugged.
3.  Contact Service Center.
Unit fails
to propel itself
1.  Drivecontrol cableinneedof  adjust-
ment.
1.  Adjust drive control cable. Refer to
“Adjustments”.
2.  Drivebelt looseor damaged.
2.  Replace drive belt.
Unit fails
to discharge snow
1.  Chute assembly clogged.
1.
Stop engine immediately and
disconnect spark plug wire. Clean
chute assembly and inside of
auger housing with clean-out tool
or a stick.
2.  Foreignobject lodgedinauger.
2.  Stop engine immediately and
disconnect spark plug wire.
Remove object from auger.
3.  Auger belt looseor damaged.
3.  Refer to Maintenance section.
13
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, , , , , , , , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 32 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website