SECTION 3: ASSEMBLY & OPERATION
NOTE: References to left, right, front and rear of the
tractor are from the operator’s position, unless
otherwise stated.
•
Before assembly, place the tractor on a firm, level
surface, disengage the PTO, stop the tractor
engine and set the parking brake.
Support
Tube
•
For convenience, pivot the seat forward and leave it
in that position until the grass collector is fully
mounted and assembled.
Mounting Bracket Assembly
•
Remove the hairpin clip and clevis pin from the rear
of the mounting bracket assembly.
Position the hooked ends of the bracket assembly
to the outside of the hitch plate and over the
shoulder bolts. See Figure 2.
Mounting
Bracket
•
Hitch Plate
NOTE: Grass catcher cover not shown here for clarity
Mounting
Bracket
Figure 3
•
Attach the grass bags using the slots shown in
Figure 4. Close the grass catcher cover.
Slots
Shoulder Bolt
Figure 2
Grass
Bag
Cover
•
Reinsert the clevis pin through the aligned holes
(Figure 2) in both the bracket assembly and the
hitch plate and secure with the hairpin clip.
IMPORTANT: There are two holes in the clevis pin. Be
sure to insert the hairpin clip in the upper hole to
properly secure the bracket assembly to the hitch plate.
Grass Bag
Attaching Grass Catcher Cover and Bags
Figure 4
•
Place the grass catcher cover assembly’s support
tube in position on the rear of unit by sliding the
support tube down through the center hole in the
mounting bracket assembly. See Figure 3.
7
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD 100, MTD 190, MTD 192, Troy-Bilt 100, Troy-Bilt 190, Troy-Bilt 192 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)