3
!
Setup and
Adjustments
#
"
NOTE: Make certain
bag is turned right side
out before assembling
(warning label will be on
the outside).
Figure 3-5
Figure 3-6
b. Secure bag to frame by working the plastic channels
on bag over frame as shown in Figure 3-6. All of the
plastic channels except center top of bag attach from
the outside of bag. Center top of bag attaches from
the inside of bag.
NOTE: Make certain
cables are routed to the
outside of the handle so
they are not in the way
when attaching the grass
catcher.
7.
Attaching Grass Catcher to Mower
a. Lift the rear discharge door on the mower, and place
the grass catcher on the pivot rod. Let go of discharge
door so that it rests on the grass catcher. See Figure
3-7.
"
!
WARNING: Never operate mower unless
the hooks on the grass catcher are firmly
seated on the pivot rod, and the rear
discharge door rests firmly against top of
the grass catcher.
8.
9.
To remove grass catcher and utilize the mulching feature:
WARNING
a. Lift rear discharge door on the mower as shown in
Figure 3-7. Lift grass catcher up and out, off of the
pivot rod. Release rear discharge door to allow it to
close rear opening of mower.
Never operate mower
unless the hooks on
the grass catcher are
firmly seated on the
pivot rod, and the
rear discharge door
rests firmly against
top of the grass
Figure 3-
The side discharge is an optional feature.
If converting to side discharge, make sure grass catcher
is off unit and rear discharge door is closed.
a. Oning plug.the sideSeeofFigurethe mower4-1. deck, lift the hinged mulch-
b. Slide the two hooks on the side discharge deflector
under the hinge pin on the hinged mulching plug
assembly. Lower the hinged mulching plug.
catcher.
All mowers are
NOTE:even whenDo notyouremoveare not themulching.hinged mulching plug at any time,
equipped with a rear
protective guard. The
guard helps eliminate
projectiles thrown
by the blade from
injuring the operator.
DO NOT REMOVE
THIS GUARD.
10.
Attaching Rear Wheels (If Not Already Attached)
Remove the hex flanged nut on the rear axle from each
side and place the rear wheel on the axle. Make sure the
spring washer is on the inside of the wheel between the
wheel and the lawnmower. See Figure 3-8. Reinsert the
flanged nut into the axle as shown, and tighten securely.
Repeat on other side.
Figure 3-8
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD 560, Troy-Bilt 560 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)