6
Maintenance & Adjustments
6
7
. After the oil has finished draining, push the end of
Maintenance
WARNING! Before performing any
maintenance or repairs, disengage the PTO,
move the drive control levers fully outward in
the neutral position, engage the parking brake,
stop the engine and remove the key to prevent
unintended starting.
the oil drain valve back in, until the tabs click into
place. Re-cap the end of the oil drain valve to keep
debris from entering the drain port.
. Replace the oil filter, and refill the engine with new
oil as instructed in the Kohler Owner’s Manual.
Air Cleaner
Service the pre-cleaner and cartridge/air cleaner
element as instructed in the Kohler Owner’s Manual.
Engine
Refer to the Kohler Owner’s Manual for all engine
maintenance intervals, procedures, specifications and
instructions.
Spark Plug
The spark plugs should be cleaned and the gap reset
once a season. Refer to the Kohler Owner’s Manual for
correct plug type and gap specifications.
Changing the Engine Oil
WARNING! If the engine has been recently run,
the engine, muffler and surrounding metal
surfaces will be hot and can cause burns to the Hydrostatic Transmission
skin. Exercise caution to avoid burns.
The zero turn tractor is equipped with dual integrated
To complete an oil change, proceed as follows:
hydrostatic pumps/transaxles that are sealed and are
maintenance-free. Fluid levels cannot be checked and
fluid cannot be added or changed.
1
. Run the engine for a short time to warm the engine
oil. The oil will flow more freely and carry away more
impurities. Use care to avoid burns from hot oil.
General Battery Information
2
3
. Locate the oil drain port on the right side of the engine.
. Pop open the protective cap on the end of the oil drain
valve to expose the drain port. Refer to Figure 6-1.
Remove the oil fill cap/dipstick from the oil fill tube.
WARNING!
•
Should battery acid accidentally splatter into
the eyes or onto the skin, rinse the affected area
immediately with clean cold water. If there is
any further discomfort, seek prompt medical
attention.
4
5
. Push the oil drain hose (packed with this manual) onto
the oil drain port. Route the opposite end of the hose
into an appropriate oil collection container with at least
a 2.0 quart capacity, to collect the used oil.
•
•
•
If acid spills on clothing, first dilute it with
clean water, then neutralize with a solution of
ammonia/water or baking soda/water.
. Pinch the tabs on the oil drain valve, then pull outward
to begin draining oil. See Fig 6-1..
NEVER connect (or disconnect) battery charger
clips to the battery while the charger is turned
on, as it can cause sparks.
Dipstick/
Oil Fill Cap
Keep all sources of ignition (cigarettes, matches,
lighters) away from the battery. The gas
Oil Fill
Tube
generated during charging can be combustible.
Oil
Filter
• As a further precaution, only charge the battery
in a well ventilated area.
•
Always shield eyes and protect skin and clothing
when working near batteries.
•
Batteries contain sulfuric acid and may emit
explosive gases. Use extreme caution when
handling batteries. Keep batteries out of the
reach of children.
Figure 6-1
19
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD RZT, Troy-Bilt RZT |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)