MTD Troy-Bilt TB4BP 4 Cycle Backpack Blower Owners Manual

STARTING/STOPPING INSTRUCTIONS
Choke Lever
WARNING:
Operate this unit only in a well-
ventilated outdoor area. Carbon monoxide exhaust
fumes can be lethal in a confined  area.
WARNING:
Avoid accidental starting. Make sure
you are in the starting position when  pulling the starter
rope (Fig. 16). To avoid serious injury,  the operator and
unit must be in a stable position  while starting.
To avoid serious personal injury, make sure  that the
blower tube is locked in place or  firmly installed.
Primer
Bulb
STARTING INSTRUCTIONS
1.
2.
3.
Check the oil level in the crankcase.   Refer to Checking
the Oil Level.
Fill the fuel tank with fresh, clean  unleaded gasoline.
Refer to Fueling the Unit.
Fully press and release the primer bulb  10 times, slowly.
Some amount of fuel should be visible  in the primer
bulb and fuel lines (Fig. 14). If  you can’t see fuel in the
bulb, press and release the bulb as  many times as it
takes before you can see fuel in  it.
Fig. 14
On/Off Switch
4.
NOTE:  The unit should be started in idle.  Do not squeeze
Place the choke lever in Position 1  (Fig. 14).
Trigger Lock
the trigger while starting (Fig. 15).
5.
Crouch in the starting position and pull  the starter rope
out about 4 inches, then pull 1–4  times in smooth and
rapid pulls to start engine (Fig. 16).
IF... the engine does not start, place the choke lever  in
Position 2 (Fig. 14) and pull 1–4  times in smooth and
rapid pulls to start engine.
Trigger
6.
Place the choke lever in Position 2  (Fig. 14) and allow
the engine to warm up for 5–10  seconds.
7.
Place the choke lever in Position 3  (Fig. 14).  The unit is
ready for use.
IF... the engine does not start, follow steps 3 through 7 again.
HOT RESTART:   If the unit is already hot, place the choke
lever in Position 3 and pull the starter rope to restart.
The unit should be started in idle.  Do not squeeze the
trigger while starting (Fig. 15).
Fig. 15
STOPPING INSTRUCTIONS
1.
Release your hand from the trigger. Allow  the engine to cool
down by idling.
2.
Press the On/Off Stop Control switch in  the OFF (O) position
and hold until the engine comes to  a complete stop (Fig. 15).
Starter Rope
Fig. 16
9
Product Specification
CategoriesLawn Mower Manual, MTD Blower and Vacuum Manuals, MTD Lawn Mower Manuals, Troy-Bilt Blower and Vacuum Manuals, Troy-Bilt Lawn Mower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 56 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website