RULES FOR SAFE OPERATION
•
IMPORTANT SAFETY INSTRUCTIONS •
READ ALL INSTRUCTIONS BEFORE OPERATING
• The cutting attachment shield must always be in place while
operating the unit. Do not operate unit without both trimming
lines extended, and the proper line installed. Do not extend
the trimming line beyond the length of the shield.
• This unit has a clutch. The cutting attachment remains
stationary when the engine is idling. If it does not, have the
unit adjusted by an authorized service technician.
WARNING: When using the unit, you must follow
the safety rules. Please read these instructions before
operating the unit in order to ensure the safety of the
operator and any bystanders. Please keep these
instructions for later use.
•
•
Adjust the D-handle to your size to provide the best grip.
Be sure the cutting attachment is not in contact with anything
before starting the unit.
•
•
•
•
•
Read the instructions carefully. Be familiar with the controls
and proper use of the unit.
Do not operate this unit when tired, ill, or under the influence
of alcohol, drugs, or medication.
Children and teens under the age of 15 must not use the
unit, except for teens guided by an adult.
All guards and safety attachments must be installed properly
before operating the unit.
Inspect the unit before use. Replace damaged parts. Check
for fuel leaks. Make sure all fasteners are in place and secure.
Replace parts that are cracked, chipped, or damaged in any
way. Do not operate the unit with loose or damaged parts.
Carefully inspect the area before starting the unit. Remove
all debris and hard or sharp objects such as glass, wire, etc.
•
•
Use the unit only in daylight or good artificial light.
Avoid accidental starting. Be in the starting position whenever
pulling the starter rope. The operator and unit must be in a stable
position while starting. See Starting/Stopping Instructions.
Use the right tool. Only use this tool for the purpose intended.
Do not overreach. Always keep proper footing and balance.
•
•
•
Always hold the unit with both hands when operating. Keep
a firm grip on both the front and rear handle or grips.
• Keep hands, face, and feet at a distance from all moving
parts. Do not touch or try to stop the cutting attachment
when it is rotating.
•
•
•
•
Do not touch the engine or muffler. These parts get extremely
hot from operation. They remain hot for a short time after you
turn off the unit.
Do not operate the engine faster than the speed needed to
cut, trim or edge. Do not run the engine at high speed when
you are not cutting.
•
•
Be aware of the risk of injury to the head, hands and feet.
Clear the area of children, bystanders, and pets. At a minimum,
keep all children, bystanders, and pets outside a 50 feet (15
m.) radius; there still may be a risk to bystanders from thrown
objects. Bystanders should be encouraged to wear eye
protection. If you are approached, stop the unit immediately.
Use only 0.080 inch (2.03 mm) diameter original equipment
manufacturer replacement line. Never use metal-reinforced
line, wire or rope. These can break off and become
dangerous projectiles.
Always stop the engine when cutting is delayed or when
walking from one cutting location to another.
•
•
• If you strike or become entangled with a foreign object, stop the
engine immediately and check for damage. Do not operate
before repairing damage. Do not operate the unit with loose or
damaged parts.
Squeeze the throttle control and check that it returns
automatically to the idle position. Make all adjustments or
repairs before using unit.
• Stop and switch the engine to off for maintenance, repair, or
for changing the cutting attachment or other attachments.
SAFETY WARNINGS FOR GAS UNITS
Use only original equipment manufacturer replacement parts
and accessories for this unit. These are available from your
authorized service dealer. Use of any unauthorized parts or
accessories could lead to serious injury to the user, or
damage to the unit, and void your warranty.
• Keep unit clean of vegetation and other materials. They may
become lodged between the cutting attachment and shield.
•
Store fuel only in containers specifically designed and
approved for the storage of such materials.
WARNING: Gasoline is highly flammable, and its
vapors can explode if ignited. Take the following
precautions:
•
•
Avoid creating a source of ignition for spilled fuel. Do not
start the engine until fuel vapors dissipate.
Always stop the engine and allow it to cool before filling the fuel
tank. Never remove the cap of the fuel tank, or add fuel, when
the engine is hot. Never operate the unit without the fuel cap
securely in place. Loosen the fuel tank cap slowly to relieve any
pressure in the tank.
Mix and add fuel in a clean, well-ventilated outdoor area where
there are no sparks or flames. Slowly remove the fuel cap only
after stopping engine. Do not smoke while fueling or mixing
fuel. Wipe up any spilled fuel from the unit immediately. Always
wipe unit dry before using.
Move the unit at least 30 feet (9.1 m) from the fueling source
and site before starting the engine. Do not smoke or allow
sparks and open flames near the area while adding fuel or
operating the unit.
• To reduce fire hazard, replace faulty muffler and spark
arrestor, keep the engine and muffler free from grass, leaves,
excessive grease or carbon build up.
OTHER SAFETY WARNINGS
•
•
•
•
Never store the unit, with fuel in the tank, inside a building
where fumes may reach an open flame or spark.
Allow the engine to cool before storing or transporting. Be
sure to secure the unit while transporting.
Store the unit in a dry area, locked up or up high to prevent
unauthorized use or damage, out of the reach of children.
Never douse or squirt the unit with water or any other liquid.
Keep handles dry, clean and free from debris. Clean after
each use. See the Cleaning and Storage instructions.
•
•
•
Keep these instructions. Refer to them often and use them
to instruct other users. If you loan someone this unit, also
loan them these instructions.
WHILE OPERATING
•
Never start or run the unit inside a closed room or building.
Breathing exhaust fumes can kill. Operate this unit only in a
well ventilated outdoor area.
SAVE THESE INSTRUCTIONS
•
Wear safety glasses or goggles that are marked as meeting
ANSI Z87.1-1989 standards. Also wear ear/hearing protection
when operating this unit. Wear a face or dust mask if the
operation is dusty. Long sleeve shirts are recommended.
•
Wear heavy, long pants, boots and gloves. Do not wear
loose clothing, jewelry, short pants, sandals or go barefoot.
Secure hair above shoulder level.
2
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD TB20DC, Troy-Bilt TB20DC |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)