ASSEMBLY INSTRUCTIONS
INSTALLING AND ADJUSTING THE D-HANDLE
INSTALL THE CUTTING ATTACHMENT SHIELD
1.
Remove the screws and bottom clamp piece that were
installed on the D-handle for shipping.
Use the following instructions if the cutting attachment shield
on your unit is not installed.
2.
Place D-handle the over the shaft housing and onto the
bottom clamp (Fig. 1). Place it a minimum of 6 inches
WARNING: Never operate the trimmer without
the cutting attachment shield in place to prevent
serious personal injury.
(15.24
cm) from the end of the shaft grip.
Shaft Grip
(4) Screws
1.
Place the cutting attachment shield onto the shaft housing.
Be sure the guard mounting bracket slides into the slot on the
edge of the cutting shield. Rotate the shield into place,
counterclockwise. The holes in the guard mounting bracket
and cutting attachment shield will line up (Fig. 3).
Shaft
Housing
Shaft Housing
Guard
Mounting
Bracket
On/Off Stop Control
Minimum 6 inches
(15.24
cm)
D-Handle
Bottom Clamp
Cutting Attachment
Shield
Fig. 1
Fig. 3
3.
Start screws with a large Flat-head or T-25 Torx
screwdriver. Do not tighten until you make the handle
adjustment.
2.
From inside the cutting attachment shield, push the square bolt
through the hole until the threaded end protrudes through the
guard mounting bracket (Fig. 4).
4.
5.
If the D-handle was pre-installed, loosen the screws on the
handle just enough to move it.
While holding the unit in the operating position (Fig. 2),
position the D-handle to the location that provides you the
best grip.
Guard
Mounting
Bracket
Washer
6.
Tighten the clamp screws evenly, until the D-handle is
secure.
Wing Nut
Square Bolt
Fig. 4
3.
Put the washer on the bolt, then screw the wing nut onto
the bolt and tighten. Figure 5 shows the installation
process from underneath the unit.
Square Bolt
Hole
Cutting
Washer
Attachment
Shield
Wing Nut
Cutting Attachment and Shield: Underside View
Fig. 5
Fig. 2
5
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD TB20DC, Troy-Bilt TB20DC |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)