ASSEMBLY INSTRUCTIONS
On some units, the D-handle may be pre-installed, requiring
only loosening screws and some adjustment. If this is the case,
go to step 4.
INSTALLING THE CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment shield
on your unit is not installed or if you ever need to re-install it.
INSTALLING AND ADJUSTING THE D-HANDLE
WARNING: Never operate the trimmer without
the cutting attachment shield in place to prevent
serious personal injury.
1.
Remove the screws and bottom clamp piece that were
installed on the D-handle for shipping.
2.
Place D-handle the over the shaft housing and onto the
bottom clamp (Fig. 1). Place it a minimum of 6 inches
1.
Slide the cutting attachment shield into the shield mount
on the cutting attachment. Align the screw holes in the
shield with the holes in the cutting attachment (Fig. 3).
(15.24
cm) from the end of the shaft grip.
Shaft Grip
(4) Screws
Shaft Housing
Shaft
Housing
Cutting Attachment
Shield
On/Off Stop Control
Minimum 6 inches
Shield Mount
(15.24
cm)
Cutting Attachment
D-Handle
Fig. 3
Bottom Clamp
2.
Place a hex lock nut into one of the three recessed holes on
the top of the cutting attachment shield (Fig 4).
Fig. 1
Hex
Lock Nut
3.
4.
5.
6.
Start screws with a large Flat-head or T-25 Torx screwdriver.
Do not tighten until you make the handle adjustment.
If the D-handle was pre-installed, loosen the screws on the
handle just enough to move it.
While holding the unit in the operating position (Fig. 2), position
the D-handle to the location that provides you the best grip.
Cutting Attachment
Shield
Tighten the clamp screws evenly, until the D-handle is secure.
Recessed Holes
Fig. 4
3.
4.
Install a screw into the hole from the bottom of the cutting
attachment shield and screw it into the nut installed in step
2
(Fig 5). Do not tighten.
Repeat steps 2 and 3 until all three screws have been
started, then tighten securely.
Screws
Fig. 2
Fig. 5
5
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD Troy-Bilt TB70FH |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)