SECTION2: LOOSEPARTS
The snow thrower is shipped with following loose parts in the carton. Please remove all loose parts from the carton
before discarding it. See Figure 1 to identify the parts noting that these parts may be referred to again in the
following sections of this manual. Part numbers are shown in parentheses.
AUGER SHEAR BOLTS
Shear Bolts
The augers are secured to the auger shaft with two shear bolts and
(710-0890A)
hex lock nuts. If you hit a foreign object or ice jam, the snow thrower
is designed so that the bolts may shear. Two replacement shear
bolts and nuts are provided for your convenience. Store in a safe
Hex Lock Nuts
(712-0429)
place until needed.
IMPORTANT: NEVER replace the auger shear bolts with standard
hex bolts. Any damage to the auger gearbox or other components
as a result of doing so will NOT be covered by your snow thrower’s
warranty.
Figure 1
SECTION3: ASSEMBLINGYOURSNOWTHROWER
NOTE: Any reference in this manual to the left or right
side of the snow thrower is observed from the
operator’s position.
•
•
Raise the upper handle assembly until it locks over
the lower handle. See Figure 2 and Figure 3.
Look at the lower rear of snow thrower frame to be
sure both cables are aligned with cable roller
guides.
Secure the upper handle and lower handle with the
two plastic wing knobs, cupped washers and
carriage bolt (eyebolt on the left side)previously
removed. See Figure 3.
IMPORTANT: Make any final adjustments as instructed
later on in this section BEFORE operating your snow
thrower. Failure to follow the instructions may cause
damage to the snowthrower.
•
•
Remove screws from the top sides and ends of the
shipping crate.
•
Set panel aside to avoid tire punctures or personal
injury.
Hex Nut
•
•
•
Remove and discard plastic bag that covers unit.
Roll unit out of crate.
Remove the lower two plastic wing knobs, cupped
washers and carriage bolt (eyebolt on the left side)
from the lower handle. See Figure 2.
Connector
Eyebolt
Wing Knobs
Figure 3
Eyebolt
•
•
Adjust the eyebolt on the chute directional control
so the rod does not come into contact with the
engine by moving the hex nut against the handle (if
necessary). Retighten the wing nut to secure the
directional control in this position.
Slide the connector down over the end of the lower
shift rod. See Figure 3. Tap the connector until it
locks on the lower shift rod.
Wing Knobs,
Washers
and Bolts
Figure 2
5
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals |
|---|---|
| Tags | MTD 550, MTD H623D, MTD H633E, MTD Snow Blower Manual, MTD Snow Boss 750, White Outdoor H623D, White Outdoor H633E, White Outdoor Snow Boss 550, White Outdoor Snow Boss 750 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)