SECTION 2: ASSEMBLING YOUR SNOW THROWER
Assembling Handle
NOTE: This Operator’s Manual covers several models.
Snow thrower features vary by model. Not all
features discussed in this manual are applicable to all
snow thrower models.
•
Remove the lower plastic wing nut, cupped washer
and carriage bolt from each side of the lower
handle. See Figure 2.
•
•
Raise the upper handle assembly until it locks over
the lower handle.
Loose Parts
•
The augers are secured to the auger shaft with two
shear pins and bow tie cotter pins. If you hit a
foreign object or ice jam, the snow thrower is
designed so that the pins may shear. Two
replacement shear pins and cotter pins are
provided for your convenience. See Figure 1. Store
these safely until needed.
Look at the lower rear of the snow thrower frame to
be sure all the cables are aligned with the cable
roller guides. Make sure the spring (found at the
end of each cable) is attached to its actuator
bracket.
Upper Handle
Cotter Pins
Steering Cable
Shear Pins
Figure 1
Tighten these
Wing Nuts
IMPORTANT: NEVER replace the auger shear pins with
standard hex bolts. Any damage to the auger gearbox
or other components from using standard bolts will not
be covered by your snow thrower’s warranty.
Lower Handle
Cable Tie
Upper
Shift Rod
IMPORTANT:
Shift Rod
Connector
Items Required For Assembly
1.
2.
3.
Pair of pliers
Engine oil
Fresh gasoline
Carriage
Bolt
Cupped
Washer
Wing
Nut
Before Assembly
Lower
Shift Rod
WARNING: Disconnect the spark plug wire
and ground it against the engine to prevent
unintended starting.
NOTE: Support Tubes are omitted from the illustration for clarity.
Figure 2
NOTE: Reference to the right hand or left hand side of
machine are observed from the operating position.
•
Secure the upper handle and lower handle with the
two plastic wing nuts, cupped washers and carriage
bolts previously removed.
•
•
Tighten the two wing nuts already in place on the
upper holes and secure the handles firmly.
Slide the shift rod connector down over the end of
the lower shift rod. Tap the connector until it locks
over the lower shift rod. See Figure 2.
NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to change
speeds or direction.
5
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals |
|---|---|
| Tags | MTD OGST 3106, MTD Snow Blower Manual, White Outdoor OGST-3106 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)