MTD White Outdoor SB45 SB55 Snow Blower Owners Manual

SECTION2:  ASSEMBLINGYOURSNOWTHROWER
Unpacking fromcarton
Raise
handle
to here
Cut along corners of the carton and lay it down flat.
See Figure 1. Remove packing material.
Remove any loose parts included with unit (i.e.,
operator’s manual, etc.).
Hand Knob
Roll unit out of carton. Check carton thoroughly for
any remaining loose part.
Remove loose parts
Figure 3
Raise the upper handle in the direction shown in
Figure 3 till it clicks into the operating position.
Make sure not to pinch or crimp the cable.
Tighten the hand knobs.
Roll unit out
Figure 1
Hardware pack
(Figure 2)
Attaching control cable
1.
Ignition Keys (2)
The control cable may already be attached to the
control handle. If not attached, complete the following
steps to attach it to the snow thrower housing.
NOTE: One key is in the switch on the snow thrower.
2.
3.
4.
5.
Eyebolt
Saddle Washer 5/16" I.D.
Hex Nuts 5/16-18 Thread (2)
Cotter Pin
“Z” End
Bottom
of Cable
Hole In
Control
Handle
Hex Nut
Saddle
Washer
Ignition
Key
Control
Housing
Cotter
Pin
Plastic
Fitting
Eye Bolt
Figure 2
Items required for assembly
1.
2.
3.
Pair of pliers (not necessary, but helpful)
Two cycle engine oil
Figure 4
Route the control cable over the lower handle.
Insert the end of the cable into the hole in the
control housing as shown in Figure 4. Push the
plastic fitting until it locks into the control housing.
Lift the control handle up, and hook the “Z” end of
the control cable into the bottom hole in the
control handle, from the outside to the inside. If
necessary, pull up on the end of the cable with a
pair of pliers to obtain slack in order to hook it into
Fresh gasoine
NOTE: All references to left or right side of the snow
thrower is from the operating position only.
Raising upper handle
Loosen the hand knob on each side of the handle.
Remove packing material, if any.
5
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website