MTD White Outdoor Snow Boss 750T Snow Blower Owners Manual

Chute Directional Control And Support
Bracket Adjustment
If the spiral at the base of the chute directional control is
not fully engaging with the notches in the lower chute
assembly, the support bracket can be adjusted inward
or outward as follows:
IMPORTANT:  Make certain to check for correct
adjustment of the shift rod as instructed under Final
Adjustments in the Assembly Section, before operating
the snow thrower.
Shift Lever
Loosen, but do NOT remove the two hex nuts
which secure the chute directional control support
bracket to the snow thrower housing.
See Figure 10.
Ferrule
Upper Shift Rod
Hairpin
Clip
Connector
Spiral
Shift Arm
Support
Lower Shift Rod
Hex Nuts
Bracket
Figure 10
Adjust the support bracket inward or outward so
that the spiral is fully engaged in the notches on the
chute before retightening the hex nuts.
Figure 11
Chute Assembly Adjustment
Shift Rod Adjustment
To adjust the shift rod, proceed as follows:
The distance snow is thrown can be adjusted by
adjusting the angle of the chute assembly. Refer to the
Chute Tilt Control in the Know Your Snow Thrower
Section.
Remove the hairpin clip and slide the shift rod
connector up, to separate the upper shift rod from
the lower shift rod. See Figure 11.
Place the shift lever into the sixth (6) position.
Rotate the shift arm clockwise (from the operators
position) as far as it will go.
Thread the upper shift rod downward until the
elbow on its lower end aligns with the hole found in
the lower shift rod.
Reconnect the upper shift rod to the lower shift rod
by reinserting the hairpin clip removed earlier and
sliding the shift rod connector back down into place.
Skid Shoe Adjustment
The space between the shave plate and the ground can
be adjusted by raising or lowering the skid shoes. Refer
to Skid Shoe Adjustment in the Assembly Section.
SECTION6:  MAINTAININGYOURSNOWTHROWER
WARNING:  Before  lubricating,  repairing,
or inspecting, disengage all clutch levers
and  stop  engine.   Wait  until  all   moving
parts   have  come   to   a  complete   stop.
Disconnect spark plug wire and ground it
against the engine to prevent   unintended
starting.
Lubrication
Gear Shaft
Lubricate the gear shaft with 6-n-1 grease at least once
a season or after every 25 hours of operation (available
at automotive stores, or order part number 737-0170).
Refer to Figure 9.
IMPORTANT: Keep all grease and oil off of the rubber
friction wheel and aluminum drive plate.
11
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website