Murray 615000X30NA 15-Inch Electric Snow Blower Owners Manual

OPERATION
Operating Instructions
In deep snow it may be necessary to make two or  three passes
over an area in order to clear it acceptably.
WARNING: The Snowthrower is designed to clear
snow from level surfaces, such as driveways and
sidewalks. Caution should be exercised while op-
erating Snowthrower on steep sloping areas.
WARNING: Never direct snow discharge towards
bystanders, glass enclosures or automobiles.
NOTE: Thoroughly inspect your Snowthrower for loose or
damaged parts prior to starting any snow clearing.
NOTE: Do not operate Snowthrower out of snow for
extended periods of time.
To Start
S
To prevent accidental starting, remove key from control  bar.
FigureAttach s7.train relief around upper handle tube as  follows:
S
S
S
Loop strain relief around handle tube.
Fasten strain relief to handle tube by inserting one  tab through
first slot (Figure 8A), pulling until both tabs  are through
(FigureLoop ex8B).tension cord in strain relief through  second slot as
illustratedSecure extinenFiguresion co8C.rd to strain relief by  looping cord around
tabsThis aswillshownprevenint dFigureisconn8D.ection in case of accidental  pull.
Connect extension cord to connecting lead form  control bar.
S
S
Key
Control Bar
S
S
NOTE: Connect Snowthrower to a UL approved two
conductor extension cord suitable for outdoor use. Use only
with a wall receptacle installed in accordance with local
codes and inspection authorities. REPLACE DAMAGED
CORD IMMEDIATELY.
Figure 7
Use this chart to determine extension cord length  and size.
Handle
Extension cord length
Wire size
25–100
Feet
16
14
Tabs
First Slot
100–150
Feet
Do not exceed 150 feet in extension cord  length.
Insert key into back of control bar.
The Snowthrower will now operate when the control bar is
squeezed. The Snowthrower will stop when the control bar  is
released. Figure 7.
Strain
Tab
Relief
A
B
WARNING: The motor is equipped with a protect-
ing device that will disconnect power to the motor
temporarily if the Snowthrower is overworked,
and will automatically reset as the motor cools.  If the mo-
tor stops, release control bar to avoid accidental starting
when the protector resets.
Tabs
Strain
Relief
Strain
Relief
Push Snowthrower forward at a rate of speed comfortable for the
operator. Don’t force the Snowthrower, it will perform better at a
slower and constant speed. The depth and  consistency of the
snow will govern the speed of forward travel.
If you find it necessary to clear snow from gravel  or irregular
surfaces, push down on handle to raise impeller  blades clear of
loose or irregular surfaces.
Extension
Cord
Extension
Cord
Second Slot
C
D
Figure 8
F-031061C
7
Product Specification
CategoriesMurray Snow Blower Manuals, Snow Blower Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 24 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website