Assembling the Snowthrower
A
A
C
B
B
C
Figure 3. Z-Hook Installation
A. Auger Drive Lever
B. Z-Hook
Figure 4. Upper Chute Installation
A. Upper Chute
B. T-Knob
C. Auger Drive Cable
2.
3.
4.
5.
Attach the auger drive cable (C, Figure 3) to the
auger drive lever (A) using the Z-hook (B).
C. Lower Chute
Remove the T-knob (B, Figure 4) and bolt on the
upper chute.
Rotate the upper chute (A) to the operating position
(past the lower chute stop)
Install the bolt and tighten the T-knob (B).
A
Engine
C
1.
The snow thrower was shipped with a container of
5W30 engine oil. Before operating, add this oil to the
engine.
2.
3.
Remove the oil fill cap/dipstick access panel (A,
Figure 5).
Remove the oil fill cap/dipstick (B). Fill to the FULL
mark on the oil fill cap/dipstick. Periodically check the
oil level. DO NOT OVER FILL.
B
4.
If not installed, install the fuel cap (C) onto the fuel
tank.
Figure 5. Add Engine Oil
A. Access Panel
B. Oil Fill Cap/Dipstick
C. Fuel Cap
9
Categories | Simplicity Snow Blower Manuals, Snow Blower Manuals |
---|---|
Tags | Simplicity 1695468, Simplicity 1695514, Simplicity 522E |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | Simplicity, Snow Blower |
Document File Type | |
Publisher | simplicitymfg.com |
Wikipedia's Page | Simplicity Outdoor |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)