Simplicity 522E 1695468 1695514 Single Stage Snow Blower Owners Manual

Troubleshooting & Service
COVER REMOVAL AND
INSTALLATION
REMOVE THE BELT COVER
1.  Remove the screws (B, Figure 13) and nuts that hold
the belt cover (E) to the auger housing.
To access the drive system or the engine, the covers
must be removed as follows:
2.
If the top cover (D) has not been removed, then
remove the screws (C) that attach the belt cover to
the top cover.
REMOVE THE TOP COVER
1.
Remove the discharge chute. See “Chute Removal
and Installation”.
3.
4.
5.
Remove screw (C) that holds the belt cover (E) to the
top cover (D).
2.
3.
Remove the fuel cap.
To remove, hold the bottom portion of the belt cover
(E) and pull down and out.
Remove the screws (A, Figure 13) and nuts from the
front of the top cover (D).
Installation of belt cover (E) is reverse of removal.
4.
5.
6.
7.
8.
Remove the screws (B) and nuts from the left and
right side of the top cover (D).
Remove the eight screws (C) on the left and right
side of the top cover (D).
Remove the five screws (C) from the back portion of
the control panel.
Carefully pull the rear of the top cover up and over
the gas tank.
Installation of top cover (D) is reverse of removal.
C
C
A
C
B
A
Figure 13.  Top Cover
C
and Belt Cover
A.  Screw, 1/4-20 x 5/8
B.  Screw, #10-24 x 1/2
C.  Screw, 1/4-14 x 3/4
D.  Top Cover
D
C
B
E.  Belt Cover
E
C
B
B
18
Product Specification
CategoriesSimplicity Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandSimplicity, Snow Blower
Document File TypePDF
Publishersimplicitymfg.com
Wikipedia's PageSimplicity Outdoor
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website