Operating the Tractor
A
B
C
Figure 8. Quick Connectors
Figure 9. Install Quick Connector Covers
A.
B.
C.
Hoses
Quick Connector
Connector Covers
Connecting Hydraulic Hoses
Bumper Removed For Clarity
The female quick connectors (B, Figure 8) require a 1/4”
male nose piece fitting (part number 173359).
Connect the hoses from the attachment hydraulic cylin-
ders (A, Figure 8) to the quick connectors (B) located
under the left foot rest. Refer to the flow diagrams in
Figure 6 to determine the correct quick connector to con-
nect to. Be sure to install the quick connector covers
(see Figure 9) after disconnecting hydraulic hoses.
A
Test Run Attachment & Check Oil
1.
2.
3.
4.
Start the engine.
Test all controls for proper function.
Check all fittings, connections, and hoses for leaks.
B
Run the tractor for at least 10 minutes. Actuate the
attachment hydraulic cylinders 10 times to bleed air
out of the hydraulic system.
Figure 10. Transmission Fluid Check
A. Hydraulic Tube
B. Drain Plug
5.
Check the oil level. Observe the oil level in the plas-
tic tube (A, Figure 10) at the rear of the unit.
Transmission
Oil Fill
There should be 1” to 1-1/2” of oil in the tube. If there
is no oil in the tube add Type-F automatic transmis-
sion oil a few ounces at a time. The transmission fill
tube is located under the seat (see Figure 11).
Figure 11. Transmission Oil Fill
15
(0 votes, average: 0 out of 5)