English / USA
STIHL recommends that you always
spray the cutter blades with STIHL resin
solvent before starting work - with the
engine stopped! You can obtain this
protective spray from your dealer. Apply
generously.
Start the engine at least 10 feet
(3 meters) from the fueling spot,
outdoors only.
!
Warning!
Never use a power tool that is damaged
or not properly maintained.
For specific starting instructions, see the
appropriate section of your power tool
and attachment manuals. Place the
power tool on firm ground or other solid
surface in an open area. Maintain good
balance and secure footing.
Keep the handles clean and dry at all
times; it is particularly important to keep
them free of moisture, pitch, oil, grease
or resin in order for you to maintain a firm
grip and properly control your power
tool.
Adjust carrying harness and hand grip to
suit your size before starting work.
!
Warning!
Starting
!
The cutting tool must be properly
tightened and in safe operating
condition. Inspect for loose parts (nuts,
screws, etc.) and for cracked, bent,
warped or damaged blades. Regularly
check the condition and tightness of the
cutter blades – with the engine stopped!
Replace damaged cutter blades before
using the power tool. Always keep
blades sharp.
Warning!
To reduce the risk of injury from blade
contact, be absolutely sure that the
cutting tool is clear of you and all other
obstructions and objects, including the
ground, because when the engine starts
at starting-throttle, engine speed will be
fast enough for the clutch to engage and
move the blades on the cutting tool.
On machines with an adjustable cutter
bar: Secure the cutter bar in the starting
position as described in the chapter
“Starting/Stopping the Engine.” If this
starting position is not the desired
cutting position, you will then need to
carefully adjust the machine to the
desired position once the engine has
returned to idle and the blades are no
longer moving.
Once the engine has started,
immediately blip the throttle trigger,
which should release the starting throttle
and allow the engine to slow down to
idle.
On machines with a defined transport
position (cutter bar folded against the
drive tube): Never start the machine in
the transport position, since the blades
are not engaged in that position and you
therefore cannot visually check to see
that they will be stopped at idle when
you start to adjust the cutter bar to the
desired cutting position (where the
blades are engaged).
With the engine running only at idle,
attach the power tool to the spring hook
of your harness (see appropriate
chapter of this manual).
!
Warning!
Your power tool is a one-person
machine. Do not allow other persons in
the general work area, even when
starting.
6
FH
| Categories | Hedge Trimmer Manuals, STIHL Hedge Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL FH |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Tiller Cultivator |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)