English / USA
Assembling the Unit
2
1
1
5
3
2
7
1
3
4
6
Horizontal cut
Mounting the loop handle
Mounting the gearbox
Hold cutting blades at an angle of
:
Fit the clamp (1) in the loop
handle (2) and place them both
on the drive tube (3).
:
:
Loosen the clamp screws (1).
0°
to 10° as you swing the hedge cutter
Push the gearbox (2) onto the drive
tube (3) - turn the gearbox back and
forth as necessary until the end of
the drive tube (3) is beyond the slot
in the clamp (see arrow). Push
horizontally.
:
Place clamp (4) in positon and
Cutting without standing directly in front
of the hedge, e.g. with flowerbed or ditch
between operator and hedge.
line up the holes.
:
:
Insert the screws (5).
gearbox fully home as far as stop.
Swing the hedge cutter in an arc towards
the outside of the hedge so that the
cuttings fall to the ground.
Fit the square nuts (6). Tighten the
:
:
Line up the gearbox on the drive
tube so that the machine support on
the powerhead points down and the
cutting blades are horizontal.
screws moderately.
:
:
Line up the loop handle.
Tighten down the screws firmly.
Tighten down the clamp screws
firmly.
HL 45
13
| Categories | Hedge Trimmer Manuals, STIHL Hedge Trimmer Manuals, Trimmer Manuals |
|---|---|
| Tags | STIHL HL 45 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Auger |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)