English
The specified angles A and B are
obtained automatically if the
recommended files or sharpening tools
and correct settings are used.
depth gauge setting, cutter length and
groove depth. It also cleans the guide
bar groove and oil inlet holes.
marked on the file holder. Rest the
file holder on the top plate and depth
gauge.
N
N
Always file from the inside to the
outside of the cutter.
File correctly
The angles must be the same on all
cutters. If the angles are uneven: Chain
will run roughly, not in a straight line,
wear quickly and finally break.
The file only sharpens on the
forward stroke – lift the file off the
cutter on the backstroke.
N
N
Select sharpening tools according
to chain pitch.
If you use an FG 2, HOS or USG
sharpener: Remove the chain from
the bar and sharpen according to
the instructions supplied with the
tool.
N
N
N
N
Avoid touching the tie straps and
drive links with the file.
Rotate the file at regular intervals
while filing to avoid one-sided wear.
Use a piece of hardwood to remove
burrs from the cutting edge.
N
N
Clamp the bar in a vise if necessary.
Sharpen the chain frequently, take
away as little metal as possible –
two or three strokes of the file are
usually enough.
Check angles with the filing gauge.
All cutters must be the same length.
As these requirements can be met only
after sufficient and constant practice:
If the cutters are not the same length,
they will have different heights. This
makes the chain run roughly and can
cause it to break.
N
Use a file holder
A file holder must be used for manual
resharpening (see table "Sharpening
Tools"). The correct filing angles are
marked on the file holder.
N
Find the shortest cutter and then file
all other cutters back to the same
length. It is best to have this work
done in the workshop on an electric
grinder.
90°
For checking angles
Use a STlHL filing gauge (special
accessory, see table "Sharpening
Tools"). This is a universal tool for
checking the filing and side plate angles,
N
Hold the file horizontally (at a right
angle to the side of the guide bar)
and file according to the angles
HT 56 C
31
| Categories | Stihl Tiller Cultivator Manuals, Tiller Cultivator Manuals |
|---|---|
| Tags | STIHL HT 56 C |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Tiller Cultivator |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)