English / USA
Taking Care of Guide Bar
Cleaning Air Filter
Chain
type
Pitch
Minimum
groove
depth
2
Picco
Rapid
Rapid
Rapid
3/8“ P
0.20"
(5.0
mm)
0.16"
mm)
1/4“
(4.0
3/8“; 0.325“
0.404“
0.24"
(6.0
mm)
3
0.28"
(7.0
mm)
If groove depth is less than specified:
Replace the guide bar.
:
The drive link tangs will otherwise
scrape along the bottom of the groove –
the cutters and tie straps will not ride on
the bar rails.
1
3
:
Turn the bar over –
Dirty air filters reduce engine power,
increase fuel consumption and make
starting more difficult.
every time you sharpen the chain
and every time you replace the
chain – this helps avoid one-sided
wear, especially at the nose and
underside of the bar.
If there is a noticeable loss of engine
power:
:
:
Regularly clean
:
:
:
Press down the throttle trigger
interlock and set Master Control
lever to cold start l
Turn twist lock above the rear
handle 90° to left (counter-
clockwise).
the oil inlet hole (1),
the oilway (2) and
the bar groove (3).
Measure groove depth –
with scale on filing gauge* – in area
used most for cutting.
Lift off shroud vertically.
*
see “Guide to Using this Manual”
MS 200
39
Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
---|---|
Tags | STIHL MS 200 |
Download File |
|
Language | English, Español |
Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
Document File Type | |
Publisher | stihl.com |
Wikipedia's Page | Stihl |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)