English / USA
Replacing Starter Rope
and Rewind Spring
If engine is down on power, difficult to
start or runs poorly at idling speed, first
check the spark plug.
1
1
:
Remove spark plug – see "Starting /
Stopping the Engine".
:
:
Clean dirty spark plug.
Check electrode gap (A) and
readjust if necessary – see
"Specifications".
1
1
:
:
:
Remove the screws (1).
:
Use only resistor type spark plugs
of the approved range.
Push the hand guard upward.
1
Rectify problems which have caused
fouling of spark plug:
Pull the underside of the fan
housing away from the crankcase
and remove it downward.
:
:
:
Too much oil in fuel mix.
Dirty air filter.
2
Unfavorable running conditions,
e.g. operating at part load.
3
Fit a new spark plug after approx.
100 operating hours
To reduce the risk of fire and burn
injury, use only spark plugs
4
4
or earlier if the electrodes are badly
eroded.
authorized by STIHL. Always press
spark plug boot (2) snugly onto
spark plug terminal (1) of the proper
size. (Note: If terminal has
detachable SAE adapter nut, it must
be attached.)
A loose connection between spark
plug boot and ignition wire
connector in the boot may create
arcing that could ignite combustible
fumes and cause a fire.
:
:
Use a screwdriver or suitable pliers
to remove the spring clip (2) from
the starter post.
Carefully remove the rope rotor
with washer (3) and pawls (4) – do
not pull the rewind spring out of the
housing – take care to avoid injury.
MS 341, MS 361, MS 361 C
47
| Categories | Chainsaw Manuals, STIHL Chainsaw Manuals |
|---|---|
| Tags | STIHL MS 341, STIHL MS 361 |
| Download File |
|
| Language | English, Español |
| Product Brand | STIHL. Stihl Inc, USA - Corporate phone: (757) 486-9100. International Support Information: http://stihl.com Email: info@stihl.com, Chainsaw |
| Document File Type | |
| Publisher | stihl.com |
| Wikipedia's Page | Stihl |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)