•
•
Push the oil drain valve in slightly, then rotate
counterclockwise and pull outward to begin
draining oil. See Figure 14.
Service the oil filter (if so equipped) as instructed
in the separate engine manual packed with your
unit.
IMPORTANT:Make certain the tractor’s discharge
chute is directed away from your house, parked cars,
etc.
2.
3.
4.
Disengage PTO, move shift lever into the neutral
position, set the parking brake, and stop engine.
Thread the hose coupler (packaged with this
manual) onto the end of your garden hose.
Attach the hose coupler to the water port on your
deck’s surface. See Figure 16.
Perform the above steps in the opposite order after oil
has finished draining.
•
Refill the engine with new motor oil.
IMPORTANT: Refill the engine with the proper
capacity and weight of motor oil as instructed in the
separate engine manual.
Service air cleaner every 25 hours under normal
conditions. Clean every few hours under extremely
dusty condition. To service the air cleaner, refer to the
separate engine manual packed with your unit.
The spark plug(s) should be cleaned and the gap reset
once a season. Spark plug replacement is
recommended at the start of each mowing season;
check engine manual for correct plug type and gap
specifications.
Hose Coupler
(Shown without
Hose Attached)
(optional)
Water Port (optional)
Figure 16
DECK WASH SYSTEM™ (Optional)
A hex plug can be found on your tractor’s deck surface.
5.
6.
Turn the water on.
This plug can be replaced with a water port to be used
as part of a separately-available deck wash system.
Use the Deck Wash System to rinse grass clippings
from the deck’s underside and prevent build-up of
corrosive chemicals. Complete the following steps after
each mowing:
While sitting in the operator’s position on the
tractor, re-start the engine and place the throttle
lever in the FAST (rabbit) position.
7.
8.
Engage the tractor’s PTO.
Remain in the operator’s position with the cutting
deck engaged for a minimum of two minutes,
allowing the underside of the cutting deck to
throughly rinse.
1.
Drive the tractor to a level, clear spot on your lawn,
near enough to a water sillcock (spigot) for your
garden hose to reach.
9. Disengage the tractor’s PTO.
10.
Turn the ignition key to the STOP position to turn
the tractor’s engine off.
11.
Turn the water off and detach the hose coupler
from the water port on your decks surface. Repeat
step 4-11 on the opposite side of the cutting deck.
Hex Plug
Figure 15
20
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Yard Machines Lawn Mower Manuals |
|---|---|
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)