Yard Machines E740 E760 Snow Blower Owners Manual by MTD

SECTION 10:  MAINTENANCE
WARNING: Disconnect
the
spark
6.   Unhook  the idler spring from the  hex bolt on the
auger housing. See figure 21.
7.   Back  out the  stop bolt  to allow  the belts  to slip
between  the bolt  and  auger  pulley.  See figure
22.
plug   wire    and   ground    against   the
engine  before  performing   any  repairs
or maintenance.
AUGER BELTS
NOTE: It  may  be necessary  to loosen  the six  nuts
that connect the frame to the  auger housing to aid in
belt removal.
1.
Remove the plastic belt  cover on the front of the
engine
by
removing
the
two
self-tapping
screws. See figure 19.
8.
Lift  the  rear auger  belt  from  the  auger  pulley,
and  slip belt  between  the  support bracket  and
the  auger  pulley.   See  figure  21.  Repeat  this
step for the front auger belt.
9.
Replace  both   auger  drive   belts   by  following
instructions in reverse order.
DRIVE BELT
1.
Follow
steps
1
through
4
of
previous
instructions.
2.   Pull  idler pulley up, and lift  belt off engine pulley
and friction wheel disc. See figure 20.
Belt
Cover
Self-Tapping
Screws
3.
Back out  the stop  bolt until  the support  bracket
rests on the auger pulley. See figure 22.
Slip   belt  between   friction  wheel   and   friction
wheel disc.  See figure 22.  Remove and replace
belt.  Reassemble  following  the   instructions  in
reverse order.
4.
Figure 19
2.
3.
4.
5.
Drain  the  gasoline  from  the  snow  thrower,  or
place a piece of plastic under the gas cap.
Tip the  snow thrower  up  and forward  so that  it
rests on the housing.
Remove   four   self-tapping    screws   from   the
frame cover underneath the snow thrower.
Roll the front and  rear auger belts off the engine
pulley. See figure 20.
NOTE:  The support  bracket  must rest  on  the stop
bolt  after  the  new  belt has  been  assembled.  See
figure 22.
Drive
Belt
Rear Auger
Belt
Support
Bracket
Engine
Pulley
Rear
Auger
Belt
Frame
Front
Auger
Belt
Front
Auger
Belt
Auger
Pulley
Support
Bracket
Spring
Idler
Auger
Engine
Pulley
Spring   Housing
Idler
Pulley
Figure 21
Idler
Pulley
Figure 20
15
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yard Machines Snow Blower Manuals
Tags, , , ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandYard Machines, E740, E760, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website