SECTION 5: MAKING ADJUSTMENTS
WARNING: NEVER attempt to clean
chute or make any adjustments while engine
is running.
•
Remove the hairpin clip and slide the connector up
to separate the upper shift rod from the lower shift
rod. See Figure 12.
Traction Control
Shift Lever
Hairpin
Clip
Refer to Final Adjustments on page 6 to adjust traction
control. If you want to check further for correct
adjustment, proceed as follows:
WARNING: Drain the gasoline out of your
snow thrower’s engine, and place a piece of
plastic film under the gas cap to avoid spillage
before beginning the job.
Flat
Washer
•
•
•
Tip the snow thrower forward, allowing it to rest on
the auger housing.
Ferrule
Remove frame cover underneath the snow thrower
by removing six self-tapping screws.
Clutch Rod
Connector
Upper Shift Rod
Hairpin Clip
With the traction control released, make sure there
is clearance between the friction wheel and the
drive plate in all positions of the shift lever.
With the traction control engaged, make sure the
friction wheel contacts the drive plate. See Figure
11.
•
Lower Shift Rod
Shift Arm
Figure 12
Axle Shaft
Sprocket
Drive Shaft
•
•
Place shift lever in sixth (6) position.
Rotate the shift arm counterclockwise (from the
operator’s position) as far as it will go.
Hex Shaft
Chain
•
•
Thread the upper shift rod downward until the
elbow on its lower end aligns with the hole found in
the lower shift rod.
Reconnect the upper shift rod to the lower shift rod
by reinserting the cotter pin removed earlier and
sliding the connector back down into place.
Drive Plate
IMPORTANT: Check for correct adjustment of the shift
rod as instructed on page 6, before operating the snow
thrower.
Friction Wheel
Figure 11
If either or both are lacking, adjust traction control as
instructed below:
Auger Control
Refer to details on page 6 to adjust the auger control.
•
•
•
Loosen the jam nut on the traction drive cable and
thread the cable in or out as necessary.
Retighten the jam nut to secure the cable when
correct adjustment is reached.
Chute Assembly
Refer to Chute Tilt Control on page 9.
Reassemble the frame cover.
Skid Shoe
NOTE: If you placed plastic film under the gas cap, be
certain to remove it before operating the snow thrower.
The space between shave plate and ground can be
adjusted by raising or lowering the skid shoes. Refer to
Skid Shoe Adjustment on page 7.
Shift Rod
To adjust the shift rod, proceed as follows.
12
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals |
|---|---|
| Tags | MTD 31AH553G401, MTD Snow Blower Manual, Yard Man 31AH553G401 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard-Man, 31AH553G401, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Lawn and Garden readers have rated Yard-Man 31AH553G401 Snow Blower Owners Manual by MTD 3.0 out of 3.0 based on 1 product reviews. Had a time getting into sight review awful