SECTION 7: SERVICING YOUR SNOW THROWER
WARNING: Before servicing, repairing, or
inspecting, disengage all clutch levers and
stop engine. Wait until all moving parts have
come to a complete stop. Disconnect spark
plug wire and ground it against the engine to
prevent unintended starting.
•
To remove shave plate, remove the carriage bolts,
belleville washers and hex nuts which attach it to
the snow thrower housing. Reassemble new shave
plate, making sure heads of the carriage bolts are
to the inside of the housing. Tighten securely.
Belt Removal and Replacement
Augers
Auger Belts
The augers are secured to the spiral shaft with two
shear bolts and hex lock nuts. See Figure 16. If you hit
a foreign object or ice jam, the snow thrower is
designed so that the bolts may shear.
•
Remove the plastic belt cover on the front of the
engine by removing the two self-tapping screws.
See Figure 17.
Shear Bolts
Belt
Cover
Self-Tapping
Screws
Figure 17
Figure 16
•
•
•
•
Drain the gasoline from the snow thrower, or place
a piece of plastic film under the gas cap.
Tip the snow thrower up and forward so that it rests
on its auger housing.
Remove six self-tapping screws from the frame
cover underneath the snow thrower.
If the augers do not turn, check if the bolts have
sheared. Two replacement shear bolts and hex lock
nuts have been provided with the snow thrower. Refer
to Loose Parts on page 5. For future use, order kit
number OEM-710-0890.
Roll the front and rear auger belts off the engine
pulley. See Figure 18.
IMPORTANT: NEVER replace the auger shear bolts with
standard hex bolts. Any damage to the auger gearbox
or other components, as a result of doing so, will NOT
be coved by your snow thrower’s warranty.
Wheel
Drive
Pulley
Shave Plate and Skid Shoes
Auger
Drive
Pulley
Wheel
Drive
Belt
•
The shave plate and skid shoes on the bottom of
the snow thrower are subject to wear. They should
be checked periodically and replaced when
necessary.
Idler
Pulley
Idler
•
To remove skid shoes, remove the four carriage
bolts, belleville washers and hex nuts which attach
them to the snow thrower. Reassemble new skid
shoes with the hardware earlier removed. Make
certain the skid shoes are adjusted to be level.
Pulley
Auger
Drive
Belts
Frame
Figure 18
14
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yard Man Snow Blower Manuals |
|---|---|
| Tags | MTD 31AH553G401, MTD Snow Blower Manual, Yard Man 31AH553G401 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yard-Man, 31AH553G401, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Lawn and Garden readers have rated Yard-Man 31AH553G401 Snow Blower Owners Manual by MTD 3.0 out of 3.0 based on 1 product reviews. Had a time getting into sight review awful