–
–
When practical, remove gas-powered equipment
from the truck or trailer and refuel it on the
ground. If this is not possible, then refuel such
equipment on a trailer with a portable container,
rather than from a gasoline dispenser nozzle.
• Do not run the engine indoors, except when starting
the engine and for transporting the snow thrower
in or out of the building. Open the outside doors;
exhaust fumes are dangerous.
•
•
Exercise extreme caution when operating on slopes.
Keep the nozzle in contact with the rim of
the fuel tank or container opening at all times,
until refueling is complete. Do not use a nozzle
lock-open device.
Never operate the snow thrower without proper
guards, and other safety protective devices in place
and working.
•
Never direct the discharge toward people or areas
where property damage can occur. Keep children
and others away.
–
–
Replace gasoline cap securely and wipe up spilled
fuel.
If fuel is spilled on clothing, change clothing
immediately.
•
•
Do not overload the machine capacity by attempting
to clear snow at too fast a rate.
•
Use extension cords and receptacles as specified by
the manufacturer for all units with electric starting
motors.
Never operate the machine at high transport speeds
on slippery surfaces. Look behind and use care when
operating in reverse.
•
•
Adjust the collector housing to clear gravel or
crushed rock surface.
•
•
Disengage power to the auger/impeller when snow
thrower is transported or not in use.
Never attempt to make any adjustments while
the engine is running (except when specifically
recommended by manufacturer).
Use only attachments and accessories approved by
the manufacturer of the snow thrower (such as wheel
weights, counterweights, or cabs).
•
Always wear safety glasses or eye shields during
operation or while performing an adjustment or
repair to protect eyes from foreign objects that may
be thrown from the machine.
•
Never operate the snow thrower without good
visibility or light. Always be sure of your footing, and
keep a firm hold on the handles. Walk; never run.
•
Never touch a hot engine or muffler.
Operation
Clearing a Clogged Discharge
Chute
•
Do not put hands or feet near or under rotating parts.
Keep clear of the discharge opening at all times.
•
Exercise extreme caution when operating on or
crossing gravel drives, walks, or roads. Stay alert for
hidden hazards or traffic.
Hand contact with the rotating impeller inside the
discharge chute is the most common cause of injury
associated with snow throwers. Never use your hand to
clean out the discharge chute. To clear the chute:
•
After striking a foreign object, stop the engine,
remove the ignition key, thoroughly inspect the snow
thrower for any damage, and repair the damage
before restarting and operating the snow thrower.
•
•
Shut the engine off!
Wait 10 seconds to be sure the impeller has stopped
rotating.
•
•
If the unit should start to vibrate abnormally, stop
the engine and check immediately for the cause.
Vibration is generally a warning of trouble.
•
Always use a cleanout tool, not your hands.
Stop the engine whenever you leave the operating
position, before unclogging the auger/impeller
housing or discharge chute, and when making any
repairs, adjustments or inspections.
Maintenance and Storage
• Check all fasteners at frequent intervals for proper
tightness to be sure the equipment is in safe working
condition.
•
When cleaning, repairing or inspecting the snow
thrower, stop the engine and make certain the
auger/impeller and all moving parts have stopped.
Disconnect the spark plug wire and keep the wire
away from the plug to prevent someone from
accidentally starting the engine.
• Never store the machine with fuel in the fuel tank
inside a building where ignition sources are present
such as hot water heaters, space heaters, or clothes
dryers. Allow the engine to cool before storing in
any enclosure.
3
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 38629C, Toro Power Max 828OE |
| Model Number | 38629C |
| Model Year | 2008 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 280000001 - 280999999 |
| Product Name | Toro Power Max 826 OE Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | Snowthrower, Two Stage Power Max |
| Swath | 26 inch |
| Discharge | Two Stage |
| Engine Manufacturer | Briggs & Stratton |
| Engine Oil Type | 20 oz. (.6l) 5w-30 or 10w-30 / API SH or higher |
| Gearbox Lubricant | 4.5 oz. (133ml) SAE 90 GL5 or higher |
| Engine Motor Model # | 15D1040112E1 |
| Engine Motor Size | 250cc |
| Engine Motor Type | 4 Cycle |
| Transmission Speed | 6 Forward/2 Reverse |
| Transmission Type | Friction Disc |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)