Yardworks 769-03250 Snow Blower Owners Manual by MTD

6
Maintaining
Your Snow
Thrower
Augers
The augers are secured to the spiral shaft with two
shear pins and cotter pins. If the auger should strike a
foreign object or ice jam, the snow thrower is designed
so that the pins may shear. Refer to Figure 6-9.
If the augers will not turn, check to see if the pins have
sheared. One set of replacement shear pins has been
provided with the snow thrower. When replacing pins,
spray an oil lubricant into shaft before inserting  new
pins.
Drive Belt Replacement
To remove and replace your snow thrower’s auger belt,
proceed as follows:
1.
Remove the plastic belt cover on the front of the
engine by removing the two self-tapping screws. See
Figure 6-9.
Figure 6-9
Drain the gasoline from the snow thrower, or place a
piece of plastic under the gas cap.
Carefully pivot the snow thrower up and forward so
that it rests on the auger housing. See Figure 6-10.
Remove the frame cover from the underside of the
snow thrower by removing four self-tapping screws
which secure it.
NEVER replace the
auger shear pins with
standard hex pins.
Any damage to the
auger gearbox or
2.
other components
as a result of failing
to do so will NOT be
covered by your snow
thrower’s warranty.
3.  a.  Use a wrench to pivot the idler pulley toward the
right. See Figure 6-11.
b. Roll the auger belt  off the engine pulley.
c. Lift  the drive belt off engine pulley.
4.
Slip the drive belt off the pulley and between friction
wheel and friction wheel disc. See Figure 6-12.
Remove and replace belt in the reverse order.
Figure 6-10
b
c
a
Figure 6-11
Figure 6-1
16
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, Yardworks Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 52 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandYardworks, 769-03250, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(3 votes, average: 2 out of 3)
Lawn and Garden readers have rated Yardworks 769-03250 Snow Blower Owners Manual by MTD 2.0 out of 3.0 based on 3 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

Yardworks 769-03250 Snow Blower Owners Manual by MTD SKU UPC Model
Mike Bruce on Dec 15, 2017.

Not a bad snowblower. Just need to keep maintenance up.


ted on Jan 25, 2014.



horst on Jan 01, 2014.



2 thoughts on “Yardworks 769-03250 Snow Blower Owners Manual by MTD

  1. My snowblower is not working properly . . . the engine starts fine and goes in forward and reverse but the auger won’t turn. Any suggestions?

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website