3
Setting Up
Your Snow
Thrower
5.
Remove the flat washer and hairpin clip from the end
of the chute directional control. See Figure 3-5.
Insert the end of the chute directional control into the
lower bracket and secure with the flat washer and hair-
pin clip just removed. If necessary, the lower bracket
can be adjusted. Refer to Chute Bracket Adjustment,
in the Adjustment Section of this manual.
IMPORTANT: Prior to operating your snow thrower, refer
to Auger Control Test on page 11. Read and follow all
instructions carefully and perform all adjustments to verify
your snow thrower is operating safely and properly.
Clean-Out Tool
WARNING: Never use your hands
to clear a clogged chute assem-
bly. Shut off engine and remain
behind handles until all moving
parts have stopped before un-
clogging.
Figure 3-
Never use your hands
to clean snow and
ice from the chute
assembly or auger
housing.
Clean-Out
Tool
The clean-out tool is mounted to the rear of the auger
housing and is designed to clear a clogged chute. Refer
to page 9 for instructions on how to properly use it.
IMPORTANT
NOTE: This item is fastened with a cable tie to the rear
of the auger housing at the factory. Cut the cable tie
before operating the snow thrower.
Prior to operating your
snow thrower, refer
to Auger Control Test
on page 11. Read and
follow all instructions
carefully and perform
all adjustments to verify
your snow thrower is
operating safely and
properly.
Tire Pressure (Pneumatic Tires)
The tires are over-inflated for shipping purposes. Check
the tire pressure before operating the snow thrower. Refer
to the tire side wall for tire manufacturer’s recommended
psi and deflate (or inflate) the tires as necessary.
NOTE: If the tire pressure is not equal in both tires, the
unit may not travel in a straight path and the shave plate
may wear unevenly.
Figure 3-6
IMPORTANT
Under any circum-
stance do not exceed
manufacturer’s recom-
mended psi. Equal tire
pressure should be
maintained at all times.
Excessive pressure
when seating beads
may cause tire/rim
assembly to burst
Lamp Wiring Harness (If equipped)
The post on the cable tie attaching the lamp wiring har-
ness to the lower handle should be plugged into the hole
in the lower handle. Pull the slack portion of the wiring
harness through the cable tie to prevent interference with
the recoil starter handle. See Figure 3-7.
Figure 3-
with force sufficient to
cause serious injury.
Refer to sidewall of
tire for recommended
pressure.
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, Yardworks Snow Blower Manuals |
|---|---|
| Tags | MTD 769-03250, MTD Snow Blower Manual, Yardworks 769-03250 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Yardworks, 769-03250, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(3 votes, average: 2 out of 3)
Lawn and Garden readers have rated Yardworks 769-03250 Snow Blower Owners Manual by MTD 2.0 out of 3.0 based on 3 product reviews. Not a bad snowblower. Just need to keep maintenance up.
My snowblower is not working properly . . . the engine starts fine and goes in forward and reverse but the auger won’t turn. Any suggestions?
my blower belts broke can you send me email page on how to replace also friction wheel? thank you if you can. ernie