•
The engine, blade, and self–propel drive
•
Do not touch the engine while it is running or shortly
after it is stopped because it will be hot enough to
cause a burn.
(self-propelled model) are designed to stop when the
control bails are released. Ensure that the control and
brake function properly before each use of the mower.
•
•
Refuel only when the engine is cool.
•
•
Disengage the self-propel mechanism or drive clutch
(self-propelled models) before starting the engine.
If the mower must be lifted to be transported, turn off
the engine and stay behind the handle until all moving
parts stop. Disconnect the spark plug wire and allow
the engine to cool.
Before using, always visually inspect the mower to
ensure that the blades, blade fasteners, and cutter
assembly are not worn or damaged. Replace worn or
damaged blades and fasteners in sets to preserve
balance.
Maintenance and Storage
•
•
•
Perform all maintenance procedures prescribed in this
manual. If major repairs are ever needed or if
assistance is desired, contact your Authorized Toro
Service Dealer.
While Operating
•
•
Do not run the engine indoors.
Start the engine carefully, according to instructions
and with your feet well away from the blade.
Before the mower is cleaned, inspected, serviced, or
adjusted, stop the engine and disconnect the wire from
the spark plug. Keep the wire away from the plug to
prevent accidental starting.
•
•
•
Always maintain secure footing. Keep a firm grip on
the handle and walk; never run. Never operate the
mower in wet grass. Mow only in daylight or in good
artificial light.
To ensure that the mower is in safe operating
condition, frequently check and keep all nuts, bolts,
and screws tight. Ensure that the blade bolt is
Mow across the face of slopes; never up and down.
Use extreme caution when changing direction on
slopes. Do not mow excessively steep slopes. Wear
skid resistant shoes on slopes.
tightened to 50 ft–lb (68 N m).
•
•
•
When servicing the blade, refer to the Maintaining the
Blade section, page 13. for correct installation and
servicing procedures.
Always wear safety glasses or eye shields during
operation to protect your eyes from foreign objects
that may be thrown from the mower. Wearing of
hearing protection, protective gloves, and a safety
helmet is advisable.
To reduce fire hazard, keep the engine free of
excessive grease, grass, leaves, and accumulations of
dirt.
Allow the engine to cool before storing the mower in
any enclosure. Do not store the mower with gasoline in
the fuel tank near any open flame, or where gasoline
fumes may be ignited by a spark.
•
Keep face, hands, and feet away from the mower
housing and cutter blade when the engine is running.
The blade can cause injury to hands and feet. Stay
behind the handle until the engine stops.
•
•
Do not overspeed the engine by changing the governor
settings.
•
•
Use extreme caution when reversing or pulling the
mower toward you.
At the time of manufacture, the mower conformed to
the safety standards in effect for rotary mowers. For
best performance and continued safety certification of
the mower, use genuine Toro replacement parts and
accessories. Replacement parts and accessories made
by other manufacturers may result in
Since the blade rotates for a few seconds after the
control bar is released, stay behind the handle until all
moving parts stop.
•
After striking a foreign object or if mower vibrates
abnormally, stop the engine and remove the wire from
the spark plug. Check the mower for damage and
make all repairs before using it again. If major repairs
are ever needed or if assistance is desired, contact your
local Authorized Toro Service Dealer.
non–conformance with the safety standards, and that
could be dangerous.
•
For storage instructions, refer to the Storage section on
page 18.
•
•
•
Stop the engine and wait for all moving parts to stop
before adjusting the height-of-cut.
Stop the blade when pushing the mower over dirt or
gravel driveways.
Stop the engine before leaving the operator’s position
behind the handle. Disconnect the wire from the spark
plug if the mower will be unattended.
4
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro 20030, Toro 20042, Toro 20043, Toro 20045, Toro SR 21S |
| Model Number | 20030, 20042, 20043, 20045 |
| Model Year | 2001 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 210000001 - 210999999 |
| Product Name | Toro Super Recycler Mower, SR-21P |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Product Type | Walk Behind Mower |
| Product Series | Toro 21" (53cm) 3 in 1 / Recycler |
| Swath | 21 inch |
| Discharge | Recycler |
| Engine Manufacturer | Briggs & Stratton |
| Engine Oil Type | 20 oz. (.6l) 30w or 10w-30 / API SH or higher |
| Engine Motor Size | 6 hp |
| Transmission Type | Hand Push |
| Spark Plug | Champion RJ19LM |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(7 votes, average: 4.86 out of 5)
Lawn and Garden readers have rated Toro 20030 20042 20043 20045 21-Inch Super Recycler SR 21S Lawn Mower Operators Manual, 2001 4.9 out of 5.0 based on 7 product reviews. Just bought a used 20042. Works fantastic! One pull and it's running! Self propelled unit that works perfectly!!!
Needs a full service and it's on duty.
Thank you!
Website set up very nice/ Easyto use
Website very well set up. It is easy to use.
Web site very well set up. Easy to use.
Website very well set up. Easy to follow.
The website is very well setup.
This is great