3.
4.
Install the cap on the fuel container.
3
2
Shake the container to mix the gasoline and oil
thoroughly.
4
1
5.
Slowly remove the cap and add the remaining amount
of gasoline.
Filling the Fuel Tank
Important
Do not overfill the fuel tank. The
gasoline-and-oil mixture must have room to expand.
1.
Clean around the fuel tank cap; do not allow snow or
water to enter the fuel tank.
5
2.
Remove the fuel tank cap and fill the fuel tank with the
gasoline-and-oil mixture until the level is 1/4 to 1/2 in.
6
mĆ5544
(6
not fill into the filler neck.
to 13 mm) below the bottom of the filler neck. Do
Figure 13
1.
2.
3.
Key switch
Primer
5.
Cord connection
(electric-start models
only; below the control
panel)
3.
Install the fuel tank cap securely and wipe up any
spilled fuel.
Electric-start button
(electric-start models
only)
6.
Choke lever
Reviewing the Maintenance
Schedule
4.
Recoil start
Review the Recommended Maintenance Schedule on
page 15. You may need to perform one or more additional
procedures before or soon after you begin operating the
snowthrower.
Starting the Engine
1.
2.
3.
Turn the key to the On position.
Move the choke lever to the right.
Operation
Cover the hole in the center of the primer with your
thumb and push the primer in twice, pausing a moment
between pushes. In extremely cold temperatures, repeat
this step if necessary.
Note: Determine the left and right sides of the machine
from the normal operating position.
Note: Take off your glove when you push in the primer
so that air cannot escape from the primer hole.
Operating Controls
Note: Do not use the choke or the primer when starting
a warm engine.
The snowthrower control panel contains a key switch, a
primer, a recoil starter, and an electric-start button
(electric-start models only). The choke lever and the cord
connection (for the electric-start models) are located below
the control panel as shown in Figure 13.
4.
Start the engine by doing the following:
For a recoil starter: Hold the snowthrower handle with
one hand and pull the recoil starter vigorously with the
other hand.
For an electric starter:
A. Connect the power cord to the snowthrower and to a
standard household power outlet.
12
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 38516, Toro CCR 2450 |
| Model Number | 38516 |
| Model Year | 2002 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 220000001 - 220999999 |
| Product Name | Toro CCR 2450 GTS Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | CCR 1000/2400/2500, Single Stage, Snowthrower |
| Swath | 20 inch |
| Discharge | Single Stage |
| Engine Manufacturer | Toro |
| Engine Oil Type | Toro 2 cycle / NMMA-TCW3 |
| Engine Motor Model # | R-tek |
| Engine Motor Size | 5 hp |
| Engine Motor Type | 2 Cycle EPA1 |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)