S Check bar and chain oil before use INSPECT AND CLEAN UNIT AND
and every 15 minutes while operating
LABELS
the saw. See GUIDE BAR AND CHAIN S After each use, inspect complete unit
OIL under the OPERATION section.
S Lubricate bar sprocket hole after each
use.
for loose or damaged parts. Clean the
unit andlabels using adamp cloth with
a mild detergent.
S Wipe off the unit and labels with a
clean dry cloth.
SERVICE AND ADJUSTMENTS
CHAIN SHARPENING
S Turn the adjusting screw counter-
clockwise to move the adjusting pin al-
most as far as it will go to the rear. Do
not remove the adjusting screw from
the unit.
Chain sharpening requires special tools.
You can purchase sharpening tools at an
authorized service dealer or go to a pro-
fessional chain sharpener.
S Hold chain with cutters facing as
WARNING: Avoid accidental start-
ing. Always unplug saw from power
source before installing a bar and/or
chain.
shown.
Tip of
Bar
CHAIN REPLACEMENT
WARNING:
Wear
protective
gloves when handling chain. The chain
is sharp and can cut you even when it is
not moving.
It is normal for anewchainto stretch dur-
ing the first 30 minutes of operation. You
should recheck your chain tension fre-
quently and adjust the chain tension as
required. See CHECK CHAIN TENSION
section.
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Cutters
Depth Gauge
Replace the old chain when it becomes
worn or damaged. Use only the Low
Kickback replacement chain specified
in the list of available replacement parts.
Thechain must complywith kickback re-
quirements of ANSIB175.1 whentested
with this saw. See your authorized ser-
vice dealer to replace and sharpen indi-
vidual cutters on your chain.
Drive Links
S Place chain around the sprocket and
fit the drive links into the guide bar
groove and then around guide bar
nose.
TO REPLACE CHAIN:
D
Disconnect the chain saw from the
power source.
Bar Nuts
Bar
Adjusting Screw
S Hold the guide bar against the saw
frame and install the bar clamp.
Be sure adjusting pin is in the adjust-
ing pin hole in the bar.
Clamp
S Removebar mounting nuts, bar clamp
plate, and old chain.
13
| Categories | Chainsaw Manuals, Poulan Chainsaw Manuals |
|---|---|
| Tags | Poulan ES300 |
| Model Year | 2003 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw |
| Document File Type | |
| Publisher | poulan.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)