10.
11.
Pull the bar forward until the chain is
snug in theguide bar groove. Ensureall
drive links are in the bar groove.
Inside view of
Chain Brake
Now, install chain brake making surethe
adjusting pin is positioned in the lower
hole inthe guidebar. Remember this pin
moves the bar forward and backward as
the screw is turned.
Adjustment located on Chain Brake
12.
Installchainbrakenutsandfingertighten
only. Once the chain is tensioned, you
will need to tighten chain brake nuts.
4.
Turn the adjusting screw by hand counter-
the adjusting pin just
clockwise
until
touches the stop. This should allow thepin
to benear thecorrect position. Further ad-
justment may be necessary as you mount
the bar.
CHAIN TENSION (Including units
with chain already installed)
NOTE: When adjusting chain tension,
make sure the chain brake nuts are finger
tight only. Attempting to tension the chain
when the chain brake nuts are tight can
cause damage.
5.
Slide guide bar behind clutch drum until
guide bar stops against clutch drum
sprocket.
Checking the tension:
Use the screwdriver end of the chain adjust-
menttool(bar tool) tomovethe chainaround
the bar. If the chain does not rotate, it is too
tight.Iftooloose, thechainwillsagbelowthe
bar.
Mount the bar
6.
Prepare the chain by checking the proper
direction. Without followingthe illustrationit
is easy toplacethechainon thesaw inthe
wrong direction. Use the illustration of the
chain to determine the proper direction.
Tip of
Bar
Chain Adjustment
Tool (Bar Tool)
Chain Brake Nuts
Adjusting the tension:
Chain tension is very important. Chain
stretches during use. This is especially true
during the first few times you use your saw.
Always check chain tension each time you
use and refuel your saw.
CUTTERS MUST FACE IN
DIIRECTION OF ROTATION
You can adjust the chain tension by loosen-
ing the chain brake nuts and turning the ad-
justing screw 1/4 of a turn while lifting up on
the bar.
Cutters
Depth Gauge
S Ifchainistootight,turnadjustingscrew1/4
turn counterclockwise.
S If chain is too loose, turn adjusting screw
1/4
turn clockwise.
Drive Links
7.
Place the chain over and behind the
clutch, fitting the drive links in the clutch
drum sprocket.
Adjusting screw
Chain Brake Nuts
Adjusting Screw -- 1/4 Turn
Place chain onto the sprocket
8.
9.
Fit bottom of drive links between the
teeth in the sprocket in the nose of the
guide bar.
S Lift up the tip of the bar and tighten the
chainbrakenutssecurely withthebartool.
S Recheck chain tension.
Fit chain drive links in bar groove.
7
Categories | Chainsaw Manuals, Poulan Pro Chainsaw Manuals |
---|---|
Tags | Poulan Pro PP4620AVHD |
Model Year | 2005 |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | Poulan Pro. Poulan Pro US phone support. Wheeled (Mowers, Tractors, Tillers, Snow Throwers): 1-800-849-1297, Handheld (Chainsaws, Trimmers, Blowers, Edgers): 1-800-554-6723, Chainsaw |
Document File Type | |
Publisher | poulanpro.com |
Wikipedia's Page | Poulan |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)