Poulan Pro PP4620AVHD Chainsaw Owners Manual

FUELING & LUBRICATION
FUELING ENGINE
In freezing weather oil will thicken, making it
necessary to  thin bar and  chain oil with  a
small amount (5 to 10%) of #1 Diesel Fuel or
WARNING:  Removefuel  capslow-
ly when refueling.
kerosene.
Bar and  chain oil must be  free
flowing for the oil system to pump enough oil
for adequate lubrication.
Genuine Poulan or Poulan  PROR bar and
chainoilis  recommendedtoprotectyourunit
against  excessive   wear  from   heat  and
friction. Poulanor Poulan PROR  oilresists
high  temperature  thinning.    If  Poulan  or
This engine is certified to operate on unleaded
gasoline. Before operation,  gasoline must be
mixed with  a good  quality  synthetic 2-cycle
air-cooled engine oil designed to be mixed at a
of   40:1.  Poulan/Weed   Eater   brand
synthetic  oil is  recommended.  Mix gasoline
andoilataratioof40:1.    A 40:1ratioisobtained
by mixing  3.2 ounces  of oil with  1 gallon of
unleaded gasoline. Included with this saw is a
ratio
Poulan PROR
bar and  chain oil  is not
available, use a good grade SAE 30 oil.
S  Never usewasteoilfor bar andchainlubri-
cation.
3.2
ounce container  of oil.    Pour the  entire
contents  of  this  container  into  1  gallon of
gasolinetoachievetheproperfuelmixture.DO
NOT USE automotive oilor boatoil. Theseoils
will cause engine damage. When mixing fuel,
follow instructions printed on container.  Once
oil  is  added  to  gasoline,   shake  container
S  Always stop the engine before  removing
the oil cap.
IMPORTANT
Experience indicates  that alcohol--blended
fuels  (called gasohol  or  using  ethanol or
methanol) can attract moisture which leads
to separation and formation of acids during
momentarily
to   assure   that   the  fuel   is
thoroughly mixed. Always read and follow the
safety rules relating to fuel before fueling your
unit.
storage.
Acidic gas  can damage  the fuel
system of  an engine while  in storage.
To
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubri-
cation.  Lubrication is provided by the auto-
matic oiler system when the oil tank is kept
filled. Lack of oil will quickly ruin the bar and
chain.  Too little  oil will  cause overheating
shownby smokecomingfromthechainand/
or discoloration of the bar.
avoid  engine  problems,  the  fuel  system
should  be emptied  before  storage for  30
days or longer. Drain the gas tank, start the
engine and let it run until the fuel  lines and
carburetor are empty.   Use fresh fuel  next
season.
See STORAGE  section for addi-
tional information.
STARTING
IMPORTANTPOINTS TOREMEMBER
WARNING:
The chain  must not
When pulling the starter rope, do not use the
full extent of the rope as this can cause the
rope to break.  Do not let starter rope snap
back.Holdthehandleandlettheroperewind
slowly.
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
BURETOR
ADJUSTMENT
within
this
manual. Avoid contact with the muffler. A hot
muffler can cause serious burns.
For cold  weather starting,  start the unit  at
FULL CHOKE; allow the engine to warm up
before squeezing the throttle trigger.
To stop  the engine  move the  ON/STOP
switch to the STOP position.
To start the engine hold the saw firmly on
the ground  as illustrated.    Make sure  the
chain is free to turn without  contacting any
object.
NOTE: Do not cut material with the choke/
fast idle lever at the FULL CHOKE position.
STARTING  A   COLD  ENGINE   (or
warm  engine after  running  out of
fuel):
NOTE:   In the  following steps, when  the
choke/fast idle lever is pulled out to  the full
extent, the correct throttle setting for starting
is set automatically.
Use only 15”---18” of rope per pull.
Hold saw firmly while pulling starter rope.
Starter rope handle
Left hand
on front
handle
1.
2.
3.
Move ON/STOP switch to the ON posi-
tion.
Pullthechoke/fastidlelever  outtothefull
extent (to the FULL CHOKE position).
Pull starter rope quickly  with your right
hand a maximum of 5 times. Then, pro-
ceed to the next step.
NOTE: If the engine sounds as if it is trying
to start before the 5th pull, stop pulling and
immediately proceed to the next step.
Right foot through rear handle
9
Product Specification
CategoriesChainsaw Manuals, Poulan Pro Chainsaw Manuals
Tags
Model Year2005
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 18 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandPoulan Pro. Poulan Pro US phone support. Wheeled (Mowers, Tractors, Tillers, Snow Throwers): 1-800-849-1297, Handheld (Chainsaws, Trimmers, Blowers, Edgers): 1-800-554-6723, Chainsaw
Document File TypePDF
Publisherpoulanpro.com
Wikipedia's PagePoulan
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website