MAINTENANCE
WARNING: To prevent accidental starting when
making any adjustments or repairs, always dis-
connect the spark plug wire and place it where
it cannot make contact with the spark plug .
HOW TO ADJUST THE CHUTE CRANK
Crank Adjusting
Bracket
If the chute crank will not rotate fully to the left or right, adjust
as follows.
Nut
Flange
1.
Remove the top cover. See “How To Remove The Top
Cover”.
1/8” (3mm)
2.
3.
Using an adjustable wrench, loosen the nuts.
Worm Gear
Move the crank adjusting bracket to allow 1/8 inch
(3mm)
clearance between the notch in the flange and
the outer diameter of the worm gear.
Figure 18
4.
Tighten the nuts.
HOW TO ADJUST THE AUGER CONTROL CABLE
The auger control cable is adjusted at the factory. During nor-
mal use, the auger control cable can become stretched and
the auger drive lever will not properly engage or disengage
the auger.
Auger Cable Spring
Boot
Auger
Bail
Jam Nut
1.
Remove the end of the auger cable spring from the au-
ger bail (see Figure 19).
Adjuster
Auger Cable
2.
3.
Remove the boot from the auger cable spring.
Figure 19
Attach the end of the auger cable spring to the auger
bail.
9. To check the adjustment, start the snow thrower. Make
sure the auger does not rotate when the auger drive lever
is released.
4.
Loosen the jam nut (see Figure 19).
5.
6.
Turn the adjuster until the auger cable is slightly slack.
Tighten the jam nut.
7.
Remove the end of the auger cable spring from the au-
ger bail and install the boot.
8.
Attach the end of the auger cable spring to the auger
bail.
1740274
22
| Categories | Husqvarna Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Husqvarna 521SSE, Husqvarna 521SSR |
| Model Year | 2006, 2007, 2008 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Husqvarna, Snow Blower |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)